Carla82

Forum Replies Created

Viewing 30 posts - 1 through 30 (of 94 total)
  • Author
    Posts
  • in reply to: Is the Heater Pro X actually quiet enough for a bedroom? #18213
    Carla82Carla82
    Member

    Not quiet enough for me either, but I’m picky about hotel room noise.

    in reply to: Does Translattia’s app need to stay open for translation? #17661
    Carla82Carla82
    Member

    Mine stayed on with the screen locked but froze once I opened maps.

    in reply to: Does the Glokore Therapy Mask come with a warranty or anything? #15634
    Carla82Carla82
    Member

    I brought mine on a work trip and it survived being tossed in a carry-on for a couple weeks, so build quality seems decent for the price. That said I never bothered chasing warranty info either. For a mask in this range I just kind of accept the risk.

    in reply to: Do battery adapters actually make sense for mixing brands? #15372
    Carla82Carla82
    Member

    Adapters are a gamble, mine worked twice then died.

    in reply to: Does TrimZa actually collect all the nail dust? #15364
    Carla82Carla82
    Member

    Mine only holds the big chunks, powder goes everywhere.

    in reply to: Do I really need a schedule for feeding two cats and a dog? #15126
    Carla82Carla82
    Member

    I mostly lurk but figured I’d add my two cents. I tried a strict schedule for my two cats and dog for about a month when I was home more, and honestly it didn’t stick. My travel just makes it impossible to keep consistent, so I went back to roughly the same times each day and everyone’s fine with that.

    in reply to: ResQVac masks vs the old red ones? #14937
    Carla82Carla82
    Member

    Soft masks actually annoyed me more than the hard ones. The ResQVac one kept sliding off my jaw when I tried it on myself, so I went back to the stiff red mask. Different faces I guess.

    in reply to: Does the JetClean work okay on car windows? #14140
    Carla82Carla82
    Member

    I still use a sponge on glass.

    in reply to: Does SavingStars work on bathroom sink hair clogs? #14119
    Carla82Carla82
    Member

    I don’t buy that it dissolves hair. I’ve used it twice on a bathroom sink and both times the water ran better for about a week, then went right back to slow. Same thing you’re describing. It loosens the gunk enough to move it along but that hair doesn’t disappear, it just ends up sitting further down the pipe until it builds up again. Second time around I pulled the pop-up and fished out what I could reach first, and honestly that did more than the powder did. The stuff near the top isn’t even the real problem anyway, it’s whatever is deeper in there. So if it’s draining fine now, fine, but I wouldn’t count on it staying that way. Mine didn’t.

    in reply to: Does GrillWizz brush head scratch older grates? #13645
    Carla82Carla82
    Member

    I don’t buy that the stainless head is the problem. My old grates got chewed up way before I ever touched one of these, and the GrillWizz didn’t add anything noticeable on top of that. If your grates are already rough, you’ve got bigger stuff to deal with than the brush.

    in reply to: Qinux Zindoggo setup question before I buy #13089
    Carla82Carla82
    Member

    I’d probably just buy it and deal with setup when it arrives. Sitting around worrying about app menus before you even have the thing in your hand seems backwards. If it turns into a hassle, you send it back.

    in reply to: Clima Pest Guard in a room with other lights on? #12807
    Carla82Carla82
    Member

    Room lights don’t seem to bother mine much, but I did notice it pulls way more when I leave it on the balcony overnight versus inside with the TV going. Brought it on a work trip and it sat in a bright hotel room for two days catching basically nothing. Dark corner, that’s where it actually earns its keep.

    in reply to: Back Restore: does it need to be plugged in the whole time? #12587
    Carla82Carla82
    Member

    I wouldn’t buy it expecting to move it around. If the manual is vague about charging, that usually means there’s no battery to charge. I’d just use it near the outlet or skip it.

    Carla82Carla82
    Member

    I wouldn’t buy it for that feature alone. It handles light stuff fine, but anything thick or sticky still needs a real wash after. The battery thing bugs me more than the cleaning honestly.

    Carla82Carla82
    Member

    The overnight thing is what I’d question more than the 8 hours. I left a similar drone battery plugged in past the green light a couple times and it got noticeably warm, which I don’t love. These aren’t expensive smart batteries that manage themselves.

    in reply to: Jetterix on a hot day, any issues? #12392
    Carla82Carla82
    Member

    Heat usually messes with the feel of things like this before it messes with how they work. I had a similar nozzle a couple of summers back, not this exact one, and the grip got soft enough that it felt weird in my hand after sitting in the sun all afternoon. Spray pattern was totally fine though. What actually killed it eventually was leaving it connected over winter, not the heat. So from what I’ve seen, a warm body and a slightly squishy trigger aren’t really warning signs of anything. The plastic warping or the seal drying out is what you’d actually notice. If it still sprays normally and nothing looks deformed, the heat probably didn’t do much. I’d pay more attention to how it’s stored long term than a few hours in the sun.

    in reply to: PolorVision for daytime driving, does it help with glare? #12077
    Carla82Carla82
    Member

    Barely worth it for daytime glare in my experience.

    in reply to: Hewelth UVClean cap vs regular bottle cap? #10433
    Carla82Carla82
    Member

    I grabbed one for a trip last spring and the smell thing is real, but only if you actually keep it charged. Mine sat dead for a week and the bottle went back to smelling like a gym sock. If plugging in a cap sounds annoying, it will be.

    in reply to: Qinux BarkBuz battery life after a few weeks? #10401
    Carla82Carla82
    Member

    Mine drains faster when I leave it out in the sun, if that helps. I use it mostly inside near the back door and it holds up fine for a week or so. Temperature seems to matter more than the barking frequency for me.

    Carla82Carla82
    Member

    I had the opposite experience honestly. The Nunawave felt less intrusive than my old pharmacy guard because it doesn’t have that hard plastic shell that always dug into my gums. Took maybe two nights to get used to, but I actually prefer the fit now.

    in reply to: Black Falcon Drone setup time – is it really quick? #9461
    Carla82Carla82
    Member

    Took me longer to get the thing out of the case than it did to get it flying. I’m not patient with setup steps, but it was pretty much unfold, connect, and go. I don’t see how you’d end up fiddling with it for an hour unless something’s actually wrong.

    in reply to: Does Translattia work better with the app set to one language pair? #9375
    Carla82Carla82
    Member

    I keep three pairs saved on mine and switching has never been an issue for me. The only thing I noticed is that it remembers the last pair used when you reopen the app, so double check that before you start talking. Accuracy stayed the same either way in my experience.

    in reply to: Does the MixMate handle thicker drinks like protein shakes okay? #9149
    Carla82Carla82
    Member

    I tried mine with a thicker shake once and it did the job, but the texture was still a bit off compared to what I’d get from an actual blender. It’s fine if you’re okay with a few tiny bits now and then. For the price and convenience, I’ll take that over hand-shaking any day, but I wouldn’t call it a smoothie maker.

    Carla82Carla82
    Member

    I would just move it for a week and see if anything changes. That’s the only way you’ll know for sure, and it’s less work than rearranging the whole room. I had mine behind a big plant stand for a while and saw no difference, then I moved it to an open outlet near the baseboard and still saw no difference. So honestly, I don’t think the furniture matters as much as people assume. These things are so weak that placement barely seems to matter either way. The bigger issue is whether they do anything at all, and I’m still not convinced after a month. If you’re happy with it where it is, leave it. Moving it around isn’t going to suddenly make pests vanish. Either it works in your space or it doesn’t, and a couch probably isn’t the deciding factor.

    Carla82Carla82
    Member

    If I were you, I’d just get it and use it whenever you remember. I travel for work too and my routine goes out the window half the time. I’ve been doing once a week at best for a while now and I still think my skin looks less blah than before. Not a miracle, but not nothing either.

    in reply to: AerioQ cooling mode leaving the room a bit damp? #8350
    Carla82Carla82
    Member

    Mine actually does the opposite. I ran it in cooling mode in a hotel room last month and the air felt drier than before, almost like a dehumidifier was running. The sticky feeling might just be how your room reacts to the temperature drop. My apartment gets that way sometimes but it’s the outside humidity coming in, not the unit itself.

    in reply to: Does the Nunawave Oral Care Pro feel bulky in your mouth? #8114
    Carla82Carla82
    Member

    It’s a fair thing to worry about. I tried one a while back and the first thing I noticed is that it’s not exactly invisible. You feel it sitting in there, especially if you have a smaller mouth. But what got me was how much the shape matters more than the size. The flexible part bends around your teeth, so it doesn’t shove your jaws apart like some night guards do. I’ve had dentist molds that were way worse.

    The tradeoff for me was the weight distribution. It’s fine when you’re just sitting still or lying down, but if you try to talk or move around much, you’re very aware it’s there. I wouldn’t call it comfortable for long stretches, more like tolerable. If you’re planning to wear it while doing anything other than relaxing, that’s probably where you’ll run into trouble.

    Carla82Carla82
    Member

    I was in the same boat before I picked mine up. I figured it would be a one-size deal and I’d be stuck buying another sharpener for my second saw. Turns out I was wrong about that. I’ve got a 3/8 chain on one saw and a .325 on the other, and the Klampero handles both without me having to fiddle with it for ten minutes between swaps. The guide sits a little differently depending on the tooth profile, but it clamps down fine and holds the angle steady.

    What changed my mind was just using it a few times across both chains. The first time I used it on the .325 I expected it to feel loose or misaligned, but it didn’t. It locked on the same way and sharpened up the cutters just as evenly. I’m not saying it’ll fit some weird oddball pitch from an old antique saw, but if you’re running the usual sizes you’ll be fine.

    I wouldn’t let the compatibility question stop you if that’s the main thing holding you back. It does what it says for the common sizes.

    Carla82Carla82
    Member

    Good to know I’m not the only one fiddling with it.

    in reply to: Omnihear battery life with daily use? #7797
    Carla82Carla82
    Member

    Charging it every night is probably realistic if you’re using it most of the day. I get around two full days out of mine before it yells at me for power, and that’s with maybe 6-7 hours of use per day. The 30 hour claim is technically right if you’re not wearing them constantly.

Viewing 30 posts - 1 through 30 (of 94 total)