Tom Bill

Forum Replies Created

Viewing 26 posts - 1 through 26 (of 52 total)
  • Author
    Posts
  • in reply to: Does GrillWizz work okay on round kettle grates? #11957
    Tom BillTom Bill
    Member

    Round kettles are just fiddly with anything motorized. I’ve watched a buddy fight his on one and the corners of the head never sit right against the curve. Not really a trick, you just end up doing extra passes and living with it.

    in reply to: Does StopWatt help with small electronics or just big appliances? #11903
    Tom BillTom Bill
    Member

    A phone charger isn’t pulling enough to matter either way. If the thing did anything for small electronics you’d see it on a meter, not by touching a charger. Warm or cool is just whatever the outlet is doing that day.

    in reply to: SpyFocus magnetic base strong enough for hotel walls? #11667
    Tom BillTom Bill
    Member

    Magnet bases are always a gamble on hotel walls. The paint there is usually cheap and slick, so I’d just use the adhesive if you actually care about it staying put. I’ve had magnets fail on surfaces that looked perfectly flat.

    in reply to: Does the WellHeater get as warm as those old oil-filled ones? #11575
    Tom BillTom Bill
    Member

    That’s normal for these little ceramic units. Mine heats up my space fast too, but it feels more like standing in front of a hair dryer than actual room heat. I still use it though.

    in reply to: Qinux AquaSylk and low water pressure? #11333
    Tom BillTom Bill
    Member

    Doubt the micro-pressurization does much when your feed line is the problem. Mine felt weaker after a couple weeks, not stronger, and the filter just added another thing to clog. If it’s already trickling, this won’t magically fix that.

    Tom BillTom Bill
    Member

    That 360 thing isn’t the gimmick. The gimmick is expecting patio-level blasting from a hose nozzle. Mine does fine on loosening mud off concrete, but it’s not stripping anything that’s been baked on for months.

    in reply to: Hewelth ReliefChain for upper back too or just neck and shoulders? #11286
    Tom BillTom Bill
    Member

    It’s a neck and shoulder thing, not an upper back device. If it slides down and lands there, that’s just gravity, not a feature. I wouldn’t count on it doing anything real for your traps.

    in reply to: Does the Qinux Gravizer need any setup before first use? #10992
    Tom BillTom Bill
    Member

    Ready to go is a stretch. Mine fired up fine but the tip wobbled until I swapped it for a different one, so check that before you start a line. As for the learning curve, yeah it’s there, I tore through a few scraps before anything looked clean.

    in reply to: Does Back Restore actually need 15 minutes or can I do less? #10894
    Tom BillTom Bill
    Member

    I cut mine to 8 minutes after a few weeks. Still felt the same as the full 15. The timer seems more like a suggestion than a requirement.

    in reply to: Does Glacier Breeze need distilled water or is tap water fine? #10558
    Tom BillTom Bill
    Member

    Tap water’s fine, minerals aren’t gonna kill it.

    in reply to: WaveMax without a window? #10517
    Tom BillTom Bill
    Member

    A window isn’t a requirement, it’s just easier. Mine sat behind the TV for a year and got the basics fine. If the kitchen is your only option, sure, try there first, but don’t assume the shelf is dead.

    in reply to: Qinux VultrioX vs the old metal blade head? #10342
    Tom BillTom Bill
    Member

    Took one off a buddy’s hands after he quit on it. I don’t think it’s some huge leap over a decent blade, but for the price of a cheap line spool it saves you the hassle of stopping to swap line out every ten minutes. Mine chews through the normal yard junk fine. If you’re already happy with your blade, probably not worth the cash.

    in reply to: AerioQ wall mount okay for a room that gets afternoon sun? #10054
    Tom BillTom Bill
    Member

    If the room is getting direct sun for hours, I would not count on this thing to do much more than blow air around. It works fine in my place, but my room is shaded most of the day. I would rather deal with the heat than expect a plug in unit to fight the sun all afternoon.

    in reply to: Qinux Vibrathea how long do you usually leave the pads on one spot? #9889
    Tom BillTom Bill
    Member

    I never really understood the whole “leave it in one spot for 20 minutes” thing. My muscles start twitching or it just gets too intense way before that. I usually do maybe 8-10 minutes max on my lower back before I have to shift it. The pads start feeling like they’re buzzing against bone or something and it’s not pleasant.

    I think those time guides are just the safe maximum, not what you’re supposed to actually do. Your body tells you when it’s had enough. If it feels weird after 5 minutes, move it. That’s basically what I do every session and it works fine for me.

    The only thing I’d say is don’t keep it in the same spot if it starts to feel numb. That’s when I call it quits for that area.

    Tom BillTom Bill
    Member

    If the pin is out, it keeps flashing. I have accidentally set mine off in my bag before and had to dig it out to shut it up. It doesn’t time out on its own. For your walks, it will be going until you physically stop it, so visibility won’t be the issue.

    Tom BillTom Bill
    Member

    Touch controls are actually the only way I use mine half the time. Voice feels awkward when you’re walking through a crowd or sitting next to someone. Tapping the frame to pause a call or skip a track is way less noticeable than talking to your glasses like you’re on a bad sci-fi set.

    Tom BillTom Bill
    Member

    You’re overthinking this. Every budget action cam I’ve seen expects you to bring your own SD card and this one is no different. The included accessories list on the product page is right there and a memory card isn’t in it. Grab a decent 64GB card so you’re not stuck staring at an empty screen on day one.

    in reply to: Does Back Restore work on a carpeted floor or does it slide around? #9219
    Tom BillTom Bill
    Member

    Good to know, thanks for the input. Sounds like it’ll be fine.

    in reply to: Keilini Heater Pro noise level in a bedroom? #9164
    Tom BillTom Bill
    Member

    I get the appeal on paper, but honestly the numbers don’t tell you much about how it actually feels at 3am. I had one in my office for a couple weeks and ended up moving it out because the sound just sat in that annoying mid-range frequency. Not loud enough to wake you, but loud enough that your brain keeps noticing it. Kind of like a computer fan that’s slightly too old.

    The bigger thing for me was the heat cycling. It kicks on, blows warm air, then shuts off and you notice the silence, then it kicks on again. That pattern is worse than constant noise for sleeping. I’d rather have a steady white noise machine than a heater that keeps starting and stopping.

    If you’re a light sleeper I wouldn’t risk it. The specs might say 37-45 dB but that doesn’t capture how the sound changes through the night.

    Tom BillTom Bill
    Member

    I’d just put it somewhere in the wallet and not think about it twice. These things aren’t that picky about position. If it’s in there, it’s doing its job.

    Tom BillTom Bill
    Member

    Ultrasound doesn’t care much about a couch. It bounces around until it fades, so unless that bookshelf is wall-to-wall and floor-to-ceiling, the signal still gets out. I’d leave it where it is and judge it on whether you’re actually seeing pests, not on the furniture layout.

    in reply to: Clima Pest Guard for camping? #7633
    Tom BillTom Bill
    Member

    I’ll be honest, I grabbed one of these for a weekend trip last year and my expectations were pretty low. The whole UV light thing in a tent sounded like a gimmick to me, but I figured for the price it was worth a shot.

    The light is actually brighter than I thought it would be. In a pitch black tent it’s noticeable, not like a flashlight or anything, but it gives off a soft glow that you can definitely see. That’s what made me think it might actually do something. And honestly, it did. I woke up in the morning, checked the tray or whatever you call it, and there were a decent amount of tiny bugs and a couple of mosquitoes in there. Not a massacre, but enough that I felt like it wasn’t a total waste.

    That said, I wouldn’t call it a miracle. The tent is small, so it doesn’t have to work hard. The battery lasted the whole night and then some, which was nice because I didn’t have to worry about charging it in the middle of nowhere. I think the key is to set it up before you settle in, give it time to attract stuff before you’re zipping up for the night.

    I’ve seen people complain that the zapping sound is annoying, but I barely noticed it once I was half asleep. If you’re expecting it to clear out a whole campsite, you’ll be disappointed. But for a tent, it’s fine. I’d probably take it again, but I’m not going to pretend it’s some essential gear.

    in reply to: ChirpyCharm notifications when birds are around? #7154
    Tom BillTom Bill
    Member

    It’s just how it works, the app was never meant to be real time.

    in reply to: ODIN SafeWave EMF on a smart TV, any reason not to? #7024
    Tom BillTom Bill
    Member

    The whole heat thing gets brought up every time someone sticks something on a TV, but the back panel barely gets warm. If you’re that worried about it, just put it near the bottom edge where it’s cooler. Mine’s been on for a while and hasn’t moved an inch.

    in reply to: Does TopCarPlay need a strong phone signal to connect? #6935
    Tom BillTom Bill
    Member

    Cell signal is irrelevant here. The adapter just creates its own Bluetooth and Wi-Fi link with the phone, so a dead zone in a parking garage won’t touch the connection itself. The only thing that might act up is loading maps or music if your phone can’t grab data. That’s a phone problem, not an adapter problem.

    in reply to: Ozoori placement in a small fridge, any spots that work better? #6891
    Tom BillTom Bill
    Member

    Door vs shelf probably doesn’t matter all that much. I stuck mine on the top shelf in the back because that’s the only spot where it wouldn’t get knocked over every time I grabbed something. The door gets bumped around too much and stuff shifts constantly, so I’d avoid that just for the hassle factor.

    Honestly, I’m not convinced placement makes or breaks this thing. It just sits there and runs. Mine has been in the same corner for a few months now and the fridge doesn’t smell like old onions anymore, but I also stopped being lazy about tossing expired stuff. Hard to say which one is doing the heavy lifting.

    If you’ve got a spot where it’s not in the way, just leave it there. The air in a small fridge gets pulled around anyway. Overthinking the exact position probably won’t change much.

Viewing 26 posts - 1 through 26 (of 52 total)