Forum Replies Created
-
Posts
-
Mine does the same thing, the short beeps come first and then the full alarm. I actually checked the manual when I first noticed it because I thought something was off, but it’s just how it warns you. The old detector I had before never did that, so it took a bit to get used to.
I wouldn’t count on it being your main repellent. I had mine out one evening and the bugs were definitely not swarming around the light, but I could still hear mosquitoes buzzing near my ears. It’s a nice extra, but I’d bring the spray for sure.
I’ve only used mine on three different chains so far, but two of them were different pitches and it handled both without any fuss. The one that surprised me was a smaller chain I grabbed for a little electric saw, I figured it would be too finicky but it clamped up fine and the angle held steady while I ran the file through.
I think people overthink the pitch thing a bit. As long as the tooth sits in the guide properly and the clamp doesn’t wobble, it seems to do the job. I’m not running anything exotic though, just the usual sizes you’d find at a hardware store. If you’re dealing with some oddball chain, that might be where it gets tricky, but for normal saws it’s been solid for me.
Battery life on these things is so dependent on little habits. I don’t think you’re doing anything wrong. I tend to turn the camera off between shots rather than leaving it in standby, and that seems to make a bigger difference than the resolution setting.
I just angle mine toward the general area where the animals come in and leave it at that. I don’t think it’s super sensitive about direction, but I do try to keep the front clear of tall grass. Seems to work okay either way.
I’d plug it in before using it. Even if it has some charge out of the box, you don’t know how long it sat in the warehouse. Took mine maybe an hour and a half on the USB-C cable before it was full, so it’s not a huge wait.
Kind of amazing how fast stuff disappears in that loose sand. I once dropped my wallet on a dry part of the beach and didn’t notice until the next day. Went back and found it half-buried just from the wind blowing sand around overnight. So yeah, things definitely shift and sink way quicker than you’d think.
I think it’s fine for a 6-year-old, but the guard only helps if they stay still. The nails come out smooth, which is nice, but it’s not something you can rush through.
Dusty smell is pretty common on a lot of these combo units the first time you hit the heat. I think it’s just whatever settled on the heating element during shipping or while it was sitting in cooling mode. Mine did that too, but it faded after a few uses.
I wouldn’t worry about it unless it gets worse or starts smelling like burning plastic. That would be a different story. The dusty thing is usually just the initial burn-off. Give it another couple of cycles and see if it clears up. If it lingers after a week, maybe check the filter or give the vents a quick wipe, but I’d bet it goes away on its own.
I’ve had mine for about three weeks now and I only charge it every few days even with the safe zone on. Seems to settle in after the first couple of charges.
Mine just overwrites the old clips when the card fills up. I haven’t formatted the card once in the time I’ve had it and it’s been fine so far.
Honestly, I wasn’t that impressed with mine on patio slabs. It’s fine for a quick rinse but it didn’t really touch the green stuff. I ended up borrowing a friend’s pressure washer anyway.
I think it’ll probably be fine. These cards are pretty thin, so unless your cardholder is already stretched to the max, you likely won’t notice much difference. I’d just give it a try.
Honestly, I’d just set it on the table and see if it works first. I tried mounting mine high up and didn’t notice enough difference to bother with the wall again.
I tried it once and honestly couldn’t tell if it made a real difference. I think people overthink it.
I only tried the wall mount because I didn’t have a good shelf spot for it. Worked fine for me, but I honestly didn’t compare it to anything else.
I’d say you’re fine for a couple grills on high. I use mine like that and it’s never quit on me before I’m done cleaning.
I haven’t really tested the zones super carefully, but I blocked out a spot where my neighbor’s security light was hitting and it hasn’t triggered since. Seems to handle that kind of thing well enough.
Should work fine. Access point mode is pretty standard, it just turns the RE700X into a wired access point so any router will hand off internet to it without issue.
I haven’t really tested it enough to say for sure, but I’d probably just leave it plugged in while on the TV. Seems like the safer bet to me.
Huh, I hadn’t really noticed mine being loose but now I’m going to have to check. It’s such a simple dial I bet they’re all a little like that though.
I think it’s just a simple snap-on thing, no tools required. Not totally sure since I haven’t actually tried swapping mine yet, but it looks pretty straightforward.
Haven’t really tracked mine closely but I think it might just depend on how often you’re running it through a full cycle. Mine still feels okay after a few months of weekend use.
I ran mine on an older 1080p TV and honestly didn’t notice anything off about it. The picture just looks like a standard retro game, nothing weird about the colors or anything. I wouldn’t worry too much about it.
I’ve used mine on a basic Qi pad I had lying around and it worked fine. No issues charging, so I wouldn’t worry about needing anything special.
I’ve been using the Enence offline for basic stuff and honestly it’s fine. The old phrasebook apps were more work to dig through. For quick chats it’s not that deep.
Thanks for all the replies. Sounds like it’s just a matter of getting used to it for a night or two. I’ll probably just give it a shot and see how it goes.