Julia Writes

Forum Replies Created

Viewing 30 posts - 31 through 60 (of 74 total)
  • Author
    Posts
  • in reply to: DashOne Pro screen too bright at night? any way to dim it? #9480
    Julia Writes
    Member

    I usually just leave mine on but turn the screen brightness down in the settings before I start driving at night. Took me a minute to find it, but it helps a lot without having to cover anything up.

    in reply to: NuraFix on headlights, anyone tried it? #9197
    Julia Writes
    Member

    I’d say try it on your headlights only if they’re just slightly dull. I did that with mine and the clarity came back for a while, but it didn’t last long before the haze started creeping back. For actual yellowed lenses you’re better off saving for a real kit.

    Julia Writes
    Member

    I think people expect too much from these things when it comes to squirrels. They’re not scared of much once they decide a food source is worth it. The cats get startled by the sound and the light, but a squirrel is basically a fuzzy little tank with a mission. I’d say keep it where it works for the cats and just accept the feeder as a squirrel buffet.

    in reply to: Does SavingStars compare to the old powder I used to buy? #9009
    Julia Writes
    Member

    I had the same reaction the first time I used it. The old stuff I was buying was more like a powder that just sat there and maybe dissolved a little, and honestly I never really knew if it was doing anything. This stuff looks like it’s having a party in the pipe. I let it foam for the full 20 minutes and then flushed it, and the water went down noticeably faster than it had in a while.

    What changed my opinion on it was using it more as a regular thing instead of just when the drain was slow. I do it about once a month now and the shower drain has been fine for a few months. That’s the part that surprised me. With the hardware store powder I was usually pouring it in every couple of weeks because the problem would come back. I haven’t had to do that with this one.

    I will say the foam can creep up if you pour too much in. First time I did it I used a generous scoop and it rose pretty high in the tub. So maybe start with a little less than you think you need and see how it behaves. But the foam itself is not a problem, it’s the stuff working. If it was just sitting there quietly I’d be more suspicious honestly.

    in reply to: Does Dustaclean handle ash or is that too fine for it? #8893
    Julia Writes
    Member

    I had a totally different experience with mine. I mainly use it for cold ash from a wood stove and it’s been fine. I just make sure to dump it right after, otherwise the dust settles in the filter and it gets harder to clean later.

    in reply to: AiraBreeze water level window, is it supposed to fog up? #8781
    Julia Writes
    Member

    Mine fogs up too but honestly I think it’s fine. I’ve had mine for about two months now and it does the same thing whenever I fill it with cooler water. The window still works for checking the level, just not as pretty to look at.

    in reply to: Does the CoolJet need ice to work well or is water enough? #8336
    Julia Writes
    Member

    I just use water and it’s fine for a desk breeze, nothing dramatic.

    in reply to: ClairLite vs my old plug-in timer, anyone else do this? #8096
    Julia Writes
    Member

    I’d still pick a dumb timer honestly, but the auto shutoff is nice for peace of mind.

    in reply to: Does the Epicooler make sense for a small bedroom in a rental? #7838
    Julia Writes
    Member

    I had one last summer and I think people expect too much from it. It’s not an AC replacement, but for a small bedroom it does take the edge off enough to sleep. I used mine mostly on the lower settings and it was fine for me. The heating side I never really tested much, so I can’t speak to that.

    in reply to: WineCork Pro vs. my old manual corkscrew: is the noise normal? #7660
    Julia Writes
    Member

    Mine is actually the opposite, I got mine and it was pretty quiet for the first week or so, then it started getting a bit more whirry as I used it more. It’s been fine ever since though, so I just figured the motor needed to break in a little.

    in reply to: Clima Pest Guard for camping? #7653
    Julia Writes
    Member

    I think you might be overestimating how much light it puts out. It’s more of a glow than a bright beam, but in a dark tent that’s actually enough to draw bugs in. I’d say go for it, just don’t expect it to light up the whole tent or anything.

    in reply to: Enence Translator battery life when traveling? #7279
    Julia Writes
    Member

    I usually just toss mine in my bag and forget about it until I need it, so I can’t say I’ve ever babied the battery. It made it through a long day of wandering around markets and asking for directions, but I also wasn’t using it nonstop. If you’re the type to have it out and talking constantly, I’d probably bring the power bank just in case.

    Julia Writes
    Member

    I’ve had mine for a couple months now and it definitely doesn’t die suddenly. It just gets to a point where you’re rubbing longer to get the same result. I switched mine out when I noticed it wasn’t pulling the scratches out as fast as it used to.

    Julia Writes
    Member

    Mine does the same faint click too and honestly I hardly even notice it anymore. The heater itself warms up my little workspace just fine so I figure it’s nothing to worry about.

    in reply to: Qinux Klampero for really small chains? #6061
    Julia Writes
    Member

    Probably works fine. If it clamps down with the screw tight enough, chain width shouldn’t be a huge issue. I’d just give it a try and see.

    Julia Writes
    Member

    From what I’ve seen, it mostly figures it out on its own. I wouldn’t say it’s perfect, but for casual back-and-forth it’s fine.

    in reply to: Coolizi Coolzy for a bedroom that gets afternoon sun? #5658
    Julia Writes
    Member

    I think the remote control would actually be handy for a bedroom setup, being able to adjust it without getting out of bed.

    in reply to: Keilini Heater Pro timer setting question #5377
    Julia Writes
    Member

    I usually just set mine for a round number like 2 or 3 hours and it shuts off when I expect it to. I don’t really mess with half-hour settings anyway, so it’s never bothered me.

    Julia Writes
    Member

    I think the ice chamber sounds like one of those features you try once and then stop bothering with. Probably works fine with just water if the office gets warm, the fan alone should help.

    Julia Writes
    Member

    Eh, it’s probably fine. If your water pressure is still good and the water feels a bit different, that’s likely the main thing it’s doing. I wouldn’t worry too much about whether you see gunk or not.

    in reply to: AiraBreeze on a timer or just leave it running? #4847
    Julia Writes
    Member

    I think the whole “must have a timer” thing is a bit overblown. I just switch mine off when I’m done with it and it’s been fine.

    in reply to: Earscribe on iOS vs Android? #4571
    Julia Writes
    Member

    I’ve used Earscribe with both an Android and an iPhone and they worked fine. The app looks a little different between the two but the translation part seemed the same. I’d say go for it, especially if you’re both planning to use it together.

    in reply to: SpyFocus night vision range for a medium room? #4152
    Julia Writes
    Member

    I’ve got mine in a similar size room and honestly it’s been fine for that. The IR isn’t going to blow you away but I can definitely tell if my dog is on the sofa or not.

    in reply to: Qinux Vibrathea pads stick well enough for neck use? #4117
    Julia Writes
    Member

    I haven’t tried mine for the neck yet but I’d imagine it depends on how much you’re twisting around. If you’re just sitting or standing still I think it should be fine.

    Julia Writes
    Member

    Honestly, I think it’s the surface texture more than anything. Wood has a little give to it, so the blade sinks in differently. The Vanotium feels harder under the knife, which can make you think it’s dulling it faster, but I haven’t noticed any actual damage.

    in reply to: Qinux BittOne battery while playing on TV? #3828
    Julia Writes
    Member

    I usually just plug mine in when it’s connected to the TV. I figure if I’m already sitting there, might as well not have to worry about it running out. Works fine for me that way.

    in reply to: SonaBuds battery life when using translation mode a lot? #3568
    Julia Writes
    Member

    I haven’t pushed mine through a super long conversation yet, but I used the translation for about 20 minutes at a family gathering and it was fine. It didn’t seem to drain dramatically or anything, just a bit more than usual. I think the case is good enough that it’s not really a worry for a trip.

    in reply to: Omnihear social mode any good for noisy restaurants? #3555
    Julia Writes
    Member

    I haven’t tried it in a super loud place yet, but at my usual restaurants it’s been okay. I wouldn’t expect it to work miracles if the place is really chaotic though.

    in reply to: How easy is it to swap brush heads on the GrillWizz? #3445
    Julia Writes
    Member

    I think it’s just a simple snap-on thing, no tools required. Not totally sure since I haven’t actually tried swapping mine yet, but it looks pretty straightforward.

    in reply to: Does the Qinux Gravizer actually work on glass? #3238
    Julia Writes
    Member

    I think it mostly depends on the glass itself. Some of my smooth glass items came out fine, but a textured bottle I tried didn’t take the engraving well at all.

Viewing 30 posts - 31 through 60 (of 74 total)