coffeeandscreens

Forum Replies Created

Viewing 26 posts - 27 through 52 (of 80 total)
  • Author
    Posts
  • coffeeandscreenscoffeeandscreens
    Participant

    Mine sits fine over my glasses but the sides do press a little after an hour or so.

    coffeeandscreenscoffeeandscreens
    Participant

    Hard surface makes a noticeable difference with these scales, that’s just how the sensors work. I keep mine on tile and it’s steady, but when I’ve used it on any kind of soft flooring the readings get jumpy enough that I don’t trust them.

    I’d say pick one spot with a hard floor and stick with it if you want consistent numbers. The carpet readings probably aren’t worth comparing against your bathroom ones.

    coffeeandscreenscoffeeandscreens
    Participant

    I feel like it’s one of those things where you just kind of know when it’s not doing anything anymore. If you’re still seeing results after a few weeks, I’d say keep going until you notice it’s not picking up scratches the way it used to. It doesn’t really stop all at once, more like it slowly gets less magical.

    in reply to: Qinux BlastVul nozzle options for glass windows? #5933
    coffeeandscreenscoffeeandscreens
    Participant

    I’ve seen a few people just use the lowest setting on glass and it seemed fine, no cracks or anything. The wide spray nozzle that comes with it spreads the water out enough that it doesn’t feel aggressive on windows. Good enough for ground level stuff without overthinking it.

    in reply to: Wood Ranger Power Leaf Blower ok for blowing off a deck? #5806
    coffeeandscreenscoffeeandscreens
    Participant

    I mean, 15 minutes is probably fine if you’re just doing a quick sweep. I’d just go for it and see how it feels, sometimes it’s enough and sometimes you wish you had an extra few minutes.

    in reply to: Coolizi Coolzy remote range any good or is it just me? #5712
    coffeeandscreenscoffeeandscreens
    Participant

    I think it depends a bit on where you place the unit. I’ve got mine on a shelf in my office and the remote works from my bed across the room no problem, but if I move it behind my monitor or something it gets a little spotty. Not totally sure if that’s a range thing or just the angle.

    in reply to: BareEarth Grounding Mat leaving a faint mark on my floor? #5605
    coffeeandscreenscoffeeandscreens
    Participant

    Oh, I think I know what you’re talking about. I had something similar happen with mine on a laminate floor but it wasn’t super obvious unless the light hit it right. I just kind of ignored it since it’s not really damaging anything, just a bit of a shadow from the backing sitting there.

    coffeeandscreenscoffeeandscreens
    Participant

    i get about 5 and a half days with mine, which is close enough for me. the 6 day claim probably depends on how much you check the app and sync, but i’ve never been disappointed by it.

    in reply to: Mouth taping at night worth it if I already use a humidifier? #5275
    coffeeandscreenscoffeeandscreens
    Participant

    I mean, you could try it for the novelty factor I guess. But if your throat already feels fine with the humidifier, it just seems like one more thing to mess with before bed for not much payoff.

    in reply to: Can the Nunawave Oral Care Pro be used if you have braces? #5111
    coffeeandscreenscoffeeandscreens
    Participant

    I mean, I get the concern about the brackets getting in the way, but the flexible mouthguard part seems like it’d be less of an issue than people think. I’d probably be more worried about whether the light is actually doing anything useful through all that metal. If you’re mainly after the gum sensitivity help, it might still be worth a shot, but I wouldn’t expect miracles until the braces are off.

    in reply to: NanoPolix on single stage paint? #4770
    coffeeandscreenscoffeeandscreens
    Participant

    I’ve used it on single stage paint and it worked fine for the light oxidation I had, but honestly I didn’t think it did much more than a regular microfiber and some elbow grease. I’d probably just stick with a basic polish if you’re not trying to overthink it.

    in reply to: TopCarPlay and audio delay in certain apps? #4653
    coffeeandscreenscoffeeandscreens
    Participant

    I mean, it’s a wireless adapter, not exactly built for watching movies, so a little audio lag doesn’t really surprise me. I just use mine for Spotify and Google Maps and haven’t had any issues that bug me. Not something I’d lose sleep over.

    in reply to: Ozoori battery life actually 4 weeks or less? #4623
    coffeeandscreenscoffeeandscreens
    Participant

    Boost mode is definitely the issue, I think most people figure that out pretty fast. I just use mine on Everyday and charge it whenever I remember, the battery lasts long enough that I don’t stress about it. The 4 week thing is probably a best case scenario, but it still works fine for keeping my fridge smelling fresh.

    in reply to: Earscribe on iOS vs Android? #4612
    coffeeandscreenscoffeeandscreens
    Participant

    Eh, I think you’ll both be fine. The app might look a tiny bit different on each phone, but the actual translation part is basically the same. I wouldn’t overthink it.

    in reply to: Qinux VultrioX on uneven ground – any tips? #4589
    coffeeandscreenscoffeeandscreens
    Participant

    I think a lot of it just depends on how you hold it, but I’ve noticed mine feels weird on bumpy mossy spots too. I usually just tilt it a tiny bit more and it’s less annoying. Not a huge deal for me honestly.

    in reply to: DrFlexa sizing question – how tight should the straps be? #4548
    coffeeandscreenscoffeeandscreens
    Participant

    The silicone strips on the inside are actually what keep it in place more than the straps themselves. I found if I crank the straps too tight it just bunches up the fabric and makes it less comfortable. I keep them medium snug and let the grip do the work.

    in reply to: Quick thing about the ODIN SafeWave EMF and phone cases #4340
    coffeeandscreenscoffeeandscreens
    Participant

    I’d say under the case is probably the way to go, mostly so it doesn’t get scratched or peel off over time. Mine hasn’t budged and I don’t really think about it anymore.

    coffeeandscreenscoffeeandscreens
    Participant

    The filter reminder thing is actually kinda handy if you’re forgetful like me. I just hit reset when I swap it out and don’t think too hard about it. Realistically I probably go closer to six weeks and the water still tastes fine.

    coffeeandscreenscoffeeandscreens
    Participant

    I dunno, I haven’t really noticed the blade feeling different personally. Maybe I’m just not that sensitive to it, but the salmon thing worked fine for me and I actually kinda like that it doesn’t smell.

    in reply to: Glacier Breeze battery life claim with the ice chamber? #3431
    coffeeandscreenscoffeeandscreens
    Participant

    I think the 10 hours is probably on low speed with no ice. Tossing ice in might make it work harder to push air through, so yeah, it’d drain faster. Not really something to worry about though, it still lasts pretty long for what it is.

    in reply to: Qinux WarmPro for a small bathroom? #3174
    coffeeandscreenscoffeeandscreens
    Participant

    I’d probably just test it out once while you’re already in the shower and see how it feels. If it’s rated for bathrooms, the steam shouldn’t be a big deal unless you’re blasting it right next to the shower head. I think people overthink moisture with these little plug-in heaters, mine’s been fine near my desk with a humidifier running.

    in reply to: ClairLite placement for a cluttered room – does it matter? #3069
    coffeeandscreenscoffeeandscreens
    Participant

    I feel like even if you’ve got furniture blocking some spots, the air still gets cleaned as it cycles through the lamp, so it’s not like you’re getting zero benefit. I think people get caught up on the surface coverage thing and forget the lamp is still running and doing something the whole time it’s on. Clutter might cut down the direct UV hits a bit, but it’s not like the lamp just stops working.

    in reply to: Glacier Breeze water tank size vs my old cooler? #2967
    coffeeandscreenscoffeeandscreens
    Participant

    Honestly, I think people overthink the tank size on these things. I use mine mostly as just a fan with a little extra cool air, so I don’t even always fill it all the way. Definitely not gonna blast like your old bulky cooler, but for a desk it’s fine if you just want some airflow that feels a bit fresher. I’d just keep a water bottle nearby if you’re worried.

    in reply to: Does the ODIN SafeWave EMF actually do anything noticeable? #2921
    coffeeandscreenscoffeeandscreens
    Participant

    I figure if it doesn’t mess with my phone’s signal or make the case bulge, it’s basically harmless. Might as well leave it on and not overthink it.

    coffeeandscreenscoffeeandscreens
    Participant

    Honestly I’d probably just take the blood sugar number as a fun extra rather than something to rely on. If it’s close enough for trends I wouldn’t sweat it too much.

    in reply to: Qinux BreezaMax angle adjustable enough for desk use? #2460
    coffeeandscreenscoffeeandscreens
    Participant

    I think you’re overthinking it a bit. The angle has been fine for me on a low desk, no slipping or anything.

Viewing 26 posts - 27 through 52 (of 80 total)