Zara W

Forum Replies Created

Viewing 26 posts - 1 through 26 (of 41 total)
  • Author
    Posts
  • Zara W
    Member

    I mostly care about the case holding up over a week rather than hitting that exact 50 number. I got through about four days of commuting and lunch walks before the case itself needed a charge, which felt reasonable for me. If you want the full advertised figure every single time you’ll probably be disappointed, but as a daily thing it was fine.

    in reply to: MrBold Pro battery life on USB-C? #11879
    Zara W
    Member

    Mine sits in my gym bag for weeks and still has charge when I pull it out. I only top it up when I happen to have the cable out for my phone anyway.

    Zara W
    Member

    Mine puts out noticeable heat in like four minutes.

    in reply to: Vital Shoulder Massager and office wear? #11475
    Zara W
    Member

    I wore mine during a video call last week and totally forgot it was on until the heat kicked in. The bulk is mostly at the back of the neck, so from the front you just look like you have a slightly thick collar. Nobody said anything, but I also didn’t ask.

    in reply to: Qinux Zindoggo collar size for a small dog? #11389
    Zara W
    Member

    Mine fits my 10 lb chihuahua mix way better than I expected, honestly. I was worried about the same thing since she’s all neck and not much else, but it stays put on walks and she doesn’t seem bothered. The chunkiness in photos is mostly the tracker part, not the band itself.

    in reply to: BareEarth Grounding Mat placement under a desk? #11003
    Zara W
    Member

    The sock thing is a real trade-off. I leave mine on and it still feels like something is happening, but barefoot definitely feels more noticeable. The cord bugged me more than I expected at first, though I stopped noticing after a week or so.

    in reply to: Keilini Heater Pro: does the plug get warm? #10870
    Zara W
    Member

    A warm plug is not automatically fine either. I had a different plug-in heater that started out slightly warm and after a couple months the plug got noticeably hotter, so I stopped using it. If it’s just barely warm that’s one thing, but if it’s actually hot to the touch I’d send it back.

    in reply to: Does SavingStars work if I have a septic system? #10730
    Zara W
    Member

    I haven’t noticed any difference in my septic since using it, but I also don’t use it nearly as often as some folks here. Maybe twice in the last six months when the bathroom sink got gross. Tank got pumped and the guy didn’t say anything about it.

    in reply to: ODIN SafeWave EMF on earbud case, does it fit okay? #10476
    Zara W
    Member

    The sticker is tiny, so it fits on a small case fine. Mine has been on for about a month and hasn’t moved. Not sure it does much for a case that sits in your pocket, though.

    in reply to: AiraBreeze in a room with a ceiling fan? #10432
    Zara W
    Member

    I’d actually turn the ceiling fan off, not because it fights the cooler but because the breeze on my skin makes the cooled air feel less noticeable. I tried both in my last place and leaving the fan running just made me crank the AiraBreeze higher for no real gain.

    Zara W
    Member

    Mine fits a standard case but the corners look a bit lumpy.

    Zara W
    Member

    Can’t say I had that problem; mine tucked into the door shelf next to the butter and never moved.

    in reply to: Does the CoolJet work okay if you don’t fill it all the way? #10050
    Zara W
    Member

    Half-filling it is honestly the only way I use mine most days since I swap it between rooms a lot and don’t want the weight. I can’t say I’ve noticed any difference in how cold the air feels, it just means I’m refilling more often if I leave it running for hours. The 8 hour thing never really applied to me anyway since I rarely leave it on that long.

    in reply to: SawShark angle consistency – or am I just bad at this? #9265
    Zara W
    Member

    I almost wonder if part of it is the chain itself and not just the tool. I picked up a used saw last year and the chain was already worn unevenly from whoever had it before. Even with the SawShark, that chain never sharpened up perfectly even. It was only when I put a fresh chain on that I could actually tell the SawShark was doing its job right. So if you haven’t tried it on a newer chain yet, that might be worth checking.

    in reply to: Does the Jetterix feel different from a classic hose nozzle? #9001
    Zara W
    Member

    I was worried about the same thing before grabbing one. But now I kinda wish I’d picked it up sooner. The spray pattern is a lot more concentrated, so it just feels more useful for stuff like the driveway or patio. My old nozzle is probably going back in the drawer for good.

    Zara W
    Member

    I was wondering the same thing before I got mine, honestly. I keep mine in the card slot right behind my main cards and I haven’t had any issues with random scans. I think the signal blocking works across the whole wallet area, not just right next to whatever card is being read.

    in reply to: PolorVision with rain on the windshield, any glare left? #8656
    Zara W
    Member

    I’ve only had mine through one proper downpour so far, and honestly the windshield drops still caught my attention way more than I expected. Not because the lenses made it worse, but just because water on glass is water on glass. What I did notice was that the glare from the spray kicked up by other cars was way less annoying, like the white haze that usually fills the air around trucks just sort of calmed down.

    I think the thing is, if you’re expecting the glasses to make the actual raindrops disappear, you’re going to be let down. But the strain on my eyes from all the reflected light bouncing around was definitely reduced. I drove about an hour in steady rain and felt way less drained afterward than I usually do. That alone makes me keep them in the car, even if they’re not some magic solution for every drop hitting the windshield.

    Zara W
    Member

    I think people get too hung up on the “blocked” thing. Sound waves bounce around a room, they don’t travel in a straight line like a laser. My couch is against one wall and I’ve got a big shelf unit on the other side, and the Repellio is plugged in near the floor behind an armchair. I haven’t noticed any mice in the three months I’ve had it, but I also can’t say I ever saw them before to compare. What I can tell you is that I tested it once by standing in the corner of the room opposite from where it’s plugged in, and I could hear a faint high-pitched noise if I really focused. So the sound is clearly getting across the room. I think furniture matters less than the distance and what the walls are made of. If you’re really unsure, maybe just move it to a different outlet for a week and see if anything changes, but I wouldn’t rearrange the whole room for it.

    in reply to: Does GrillWizz handle the grates while they’re still warm? #8508
    Zara W
    Member

    I’ve actually found that a little warmth helps a ton, but I’m not talking about right off the flame. I usually let the grill sit for maybe ten minutes after I finish cooking, so it’s still pretty warm but not sizzling. The grease seems to soften up just enough that the Wizz glides over it without me having to press down hard. I haven’t noticed any issue with the brush head, it’s held up fine so far.

    in reply to: CarbonOne Safe vs old detector: is the beep pattern different? #8283
    Zara W
    Member

    It’s funny you mention that because I remember the exact same thing happening when I first swapped mine in. I was standing there waiting for the loud blast and instead got these little chirps first, like the thing was clearing its throat. I thought maybe I didn’t press it in all the way or something. But after a few weeks with it, I actually think the pattern makes sense for how I use it. With the old one, any little thing would set it off and it was all or nothing. The short beeps kind of let me glance at the display and see what it’s picking up before the room turns into a fire drill.

    That said, I haven’t had a real emergency yet, so I can’t say if the actual alarm is as scary loud as the old one. I just hope it doesn’t decide to do the quiet chirps during something serious. I’d rather have the panic beep than a polite heads-up at 3am. Are you keeping it in the same spot as the old one?

    in reply to: Does the CoolCove work okay in a room with high ceilings? #8190
    Zara W
    Member

    I think it really comes down to where you’re sitting rather than the ceiling height itself. I have mine in a spot with tall ceilings and it keeps my corner comfortable, but if I move to the other side of the room I can tell the difference. It’s one of those things where you just gotta figure out if it works for your layout.

    in reply to: ClairLite vs my old plug-in timer, anyone else do this? #8092
    Zara W
    Member

    I think the auto shutoff is one of those things that sounds nice on paper but actually matters way more than you expect. I had a basic timer before too, and honestly the difference for me wasn’t just the convenience, it was knowing I couldn’t accidentally walk into a room while the thing was still running. With the old plug-in timer I’d sometimes forget which outlet it was on or lose track of the schedule, and there were a couple times I nearly opened the door while the bulb was active. That alone made the upgrade feel worth it, even if the actual sanitizing results seem about the same.

    That said, I do wonder if I’d feel differently if I only used it in one spot. I move mine around a lot, so having it shut off on its own saves me from my own forgetfulness. If you’re the type who never forgets to unplug things, the cheap route probably works fine.

    in reply to: Qinux ScryneX without a frame – does it stay flat enough? #7978
    Zara W
    Member

    I think it depends on how much you’re willing to fiddle with it. I had mine up with tape for a while and the middle stayed fine, but the corners just would not cooperate no matter what I did. It’s not terrible, but if you’re the type who notices those little waves during bright scenes, it might bug you more than you expect.

    in reply to: Does LumaGlasses translation work well in noisy places? #7614
    Zara W
    Member

    I think it handles noise better than I expected, honestly. I wore mine in a crowded food hall with people yelling orders and clattering dishes and it still caught the person I was talking to without much trouble. The only time I really had to repeat things was when the other person had a super thick accent, and that would be hard for anything to catch. I’d say busy street noise is fine, it’s more about the person speaking than the environment.

    Zara W
    Member

    I think the IP68 rating is probably fine for actual swimming, but I’m with you on being wary about the sensors long term. I’ve only done a few short pool sessions with mine, nothing intense, and it’s been totally fine. I just rinse it off after and haven’t noticed any issues yet. That said, I’d probably still be a little cautious about doing laps every single day until I’d worn it more.

    in reply to: Back Restore vs the old TENS unit I used to borrow? #7435
    Zara W
    Member

    Honestly the TENS comparison is the reason I almost didn’t try this, but it’s nothing like that. The TENS always felt like it was buzzing my skin, whereas this is more of a heavy, rhythmic push that actually moves through the muscle. I found myself just lying there waiting for the next pulse because it felt like a real massage. The vibration is the least weird part of it for me, honestly.

Viewing 26 posts - 1 through 26 (of 41 total)