Forum Replies Created
-
AuthorPosts
-
20 de September de 2026 at 08:25 in reply to: How does DrFlexa compare to an old neoprene sleeve? #12027
Susan KennetMemberI only really notice the stabilizers when I’m actually bending deep, like getting up off the floor. For just walking around they’re basically a non-issue for me. The thing I’d actually think about is the straps, mine needed a couple of wears before I figured out how tight to get them without cutting in.
17 de September de 2026 at 16:59 in reply to: Qinux Vibrathea – does the heat mode actually feel warm or is it just a gimmick? #11599
Susan KennetMemberThe heat on mine is noticeable but subtle, kind of like a warm pack that’s been sitting out for a bit. It definitely helps loosen things up, but I wouldn’t buy it just for that feature. The stimulation part does more for my shoulders than the heat ever did.
Susan KennetMemberProbably fine for one person at a desk.
Susan KennetMemberI’ve used translation mode for a few episodes of a French show and it actually kept up fine with normal back and forth talking. It only struggled when two people were yelling over each other, which is kind of a mess anyway. The bigger thing for me is you can’t really glance away from your phone since the app stays open.
14 de September de 2026 at 01:32 in reply to: Herz P1 Smart Ring – do I need to wear it on a specific finger? #11022
Susan KennetMemberI’ve had mine on my middle finger for a couple months now and it’s been fine. Honestly I just picked that one because it was the best fit in the sizing kit. Never bothered switching hands.
13 de September de 2026 at 16:52 in reply to: Does the Qinux WarmPro work in a room with high ceilings? #10975
Susan KennetMemberHigh ceilings kill these little plug-in heaters, period. I tried one in my brother’s place with a vaulted ceiling and it did nothing unless you were basically touching it. Anyone saying otherwise probably has a lower ceiling than they think.
13 de September de 2026 at 08:20 in reply to: Qinux BitBip 89 – can I add my own games easily? #10920
Susan KennetMemberEasier to just enjoy the built-in list, if I’m honest.
Susan KennetMemberI still haven’t bought this one yet, mainly because the whole “wait until it’s dry but not too dry” thing sounds annoying to figure out. I did try a different spray scratch product last year and waiting too long definitely made it harder to wipe, so I get the worry. Curious if people notice it actually mattering much once the cloth hits the paint.
12 de September de 2026 at 06:05 in reply to: Does the Enence Translator need Wi-Fi for every language? #10749
Susan KennetMemberThe 68 languages thing is a little misleading, because I remember reading somewhere that only a small set works truly offline. The rest need a connection. I’d rather just use a translation app on my phone and save the money, honestly.
11 de September de 2026 at 04:18 in reply to: How long should I wait before adjusting the SleepZee? #10577
Susan KennetMemberI wouldn’t use the jaw adjustment as the thing to wait on, at least not for a full month. Mine started feeling off around week two, and it turned out the molded part had loosened up, not the jaw setting. I remolded it and that fixed way more than fiddling with the screw would have.
Susan KennetMemberI actually kept mine in a bedroom for about two months before I ever tried moving it around, and it picked up plenty of channels there. No window in sight. The one thing that surprised me was how much the building itself mattered more than the window situation. I’m on the ground floor surrounded by other units, and I still got the main local stations without much fuss. The picture was a little flaky on rainy days, but that happened regardless of where I put the thing. So I’d say the window thing gets overstated. It helps maybe at the margins, but it’s not like the antenna is blind without one. If you’re in a decent signal area you have a real shot at it working from a shelf. If you’re far from the towers, no window is going to save you anyway.
Susan KennetMemberI’d probably stop it too, but that’s just how I usually do it.
8 de September de 2026 at 20:49 in reply to: Is it normal for the Herz P1 Smart Scale to show a different heart rate than my watch? #10220
Susan KennetMemberThe heart rate on these scales is more of a bonus feature than something I’d rely on for accuracy. Mine tends to read a bit higher if I step on right after moving around the house, so I just make sure I’m fully relaxed before I check it. I wouldn’t expect it to match your watch perfectly all the time.
7 de September de 2026 at 03:53 in reply to: SpyFocus battery okay if left on motion detect all day? #9934
Susan KennetMemberI think you’d probably get a couple days out of it, but it really depends on what’s triggering it. I’ve had mine in a spare room where not much goes on and it’ll sit there for like two days and still have maybe half the battery left when I finally check the app. But that’s with barely any motion happening.
The display of the battery meter itself can be a little confusing too. One day I thought it was about to die because it showed one bar, then it kept running for hours after that. So I never really trust it until it actually shuts off.
For your situation, I’d say plan on charging every night if you want to be safe, especially if there’s activity near it. You’ll probably get through a full day without issues, but pushing it to day two feels like a gamble depending on what it’s seeing. I just got into the habit of plugging it in when I’m sitting at my desk anyway.
5 de September de 2026 at 09:52 in reply to: Qinux ScryneX vs. my old pull-down screen for daytime use? #9670
Susan KennetMemberI keep coming back to the same thought whenever this screen comes up: people expect it to be a magic fix for daylight, but it is still a screen, not a blackout curtain. The material is fine for what it is, but if your room is bright, you are going to be fighting that no matter what you hang up. My old pull-down was a pain too, so I get the appeal.
4 de September de 2026 at 10:02 in reply to: Does the AlarmTag strobe light stay on the whole time in alarm mode? #9518
Susan KennetMemberI think for what you’re describing, continuous flashing is the whole point of having a strobe on a safety device. If it timed out, that would kind of defeat the purpose. A steady light that stays on while the pin is out seems like the only sensible design, otherwise you’d have to hope someone resets it at the right moment. That said, I would personally prefer a model where I could choose between just the light or just the sound, depending on the situation.
3 de September de 2026 at 01:21 in reply to: SawShark angle consistency – or am I just bad at this? #9298
Susan KennetMemberThe guide helps keep the file at a consistent angle, but it doesn’t control how level you hold it against the tooth. I found that if I let the tool tip slightly while filing, the angle changes even though the guide is still in place. It takes a bit of a steady hand no matter what.
29 de August de 2026 at 21:43 in reply to: PolorVision with rain on the windshield, any glare left? #8653
Susan KennetMemberI’m still on the fence about mine honestly. I’ve only had them out in a real downpour once and that was more of a steady heavy rain on the highway, not a storm with water just hammering down. The road spray and the headlights from oncoming traffic were definitely calmer, that part I can say for sure. But the drops on the windshield itself? They were still just as distracting as ever. I think I was squinting through the wiper streaks more than anything else.
What I did notice was that the glare from the wet asphalt was way less harsh, which made it easier to see the lines and the cars ahead. So they did something, just not the whole job. I can’t tell if it’s the lenses or just me getting used to the conditions, but I’d be curious to try them in a proper storm to see if the rain on the glass becomes less of a problem once the other reflections are gone. Might be that your brain can focus better when it’s not dealing with all that bouncing light at the same time.
I also wonder if it depends on the car and how your windshield is angled. Mine is pretty flat so the water sits there more. A friend with a sportier car says the rain rolls right off and he barely notices it. So maybe it’s not just the glasses. I’m leaning toward keeping mine because the night time difference alone is worth it to me, but the rain thing is still a bit of a maybe.
28 de August de 2026 at 21:47 in reply to: Does StopWatt actually help with power surges or is that just a bonus? #8499
Susan KennetMemberI think the surge protection angle is where a lot of the confusion comes from, honestly. Like, if you’re expecting this little plug-in thing to be the same as a beefy surge protector that you’d plug your expensive TV into, you’re probably going to be let down. I got one mostly for the energy angle, but I did notice that my lights don’t flicker as much when the AC kicks on or when something heavy starts up. That’s the kind of “surge” I feel like it actually helps with, the small everyday dips and spikes, not a lightning strike or a major storm event.
I live in a place where we get random brownouts in the summer, and I can’t say I’ve seen any difference in how my appliances behave during those. My fridge and computer have always just kicked back on when the power comes back, same as before. So for actual storm protection, I wouldn’t rely on it. But for just smoothing out the little hiccups that make your electronics act weird, I think it does something. It’s one of those things where you don’t really notice it until you realize you haven’t had to reset the microwave clock in a while.
So I’d say if you’re buying it for storm protection, you might be disappointed. But if you just want it as a little extra layer of steadiness, it’s not a bad thing to have around.
28 de August de 2026 at 18:00 in reply to: Ryoko Pro vs old pocket router, is the connection really that much better? #8474
Susan KennetMemberI’m less worried about the auto network stuff than about how long these things actually last on battery once they’re a few months old. My old unit started dying after a few hours even when it said it was fully charged, so I’m curious if the Ryoko holds up better or if it’s the same story with a prettier app.
24 de August de 2026 at 07:51 in reply to: Qinux Zindoggo safe zone vs old fence setting, how exact is it? #7933
Susan KennetMemberI actually have to disagree with the general praise here. I switched from another brand to the Zindoggo and my escape alerts were consistently late. My dog cleared the boundary and was already two properties down before my phone buzzed. The fence radius itself seemed fine on the map, but the notification timing was the whole point for me, and it just didn’t hold up. I ended up going back to my old tracker.
Susan KennetMemberI keep seeing people say textured dashboards are a no go for suction mounts, and honestly that makes sense. But one thing I would add is that the angle of the dash matters too. If it curves away sharply, even a smooth surface is going to be annoying because you can’t get the mount to sit flat enough to hold properly.
20 de August de 2026 at 16:10 in reply to: Does the SawShark work on all chain sizes or just some? #7541
Susan KennetMemberI get why the vague compatibility talk is annoying. I looked into it for mine and honestly the whole thing hinges on your chain’s numbers, not the brand. If you are running something standard you are probably fine, but I would not assume it just because it says it fits “many” chains.
Susan KennetMemberI’d lean toward the wiring being the culprit. Older outlets tend to get loose and worn over time, so they don’t hold the plug securely, which causes arcing and heat buildup. I’ve seen that happen with a different 800W heater in a place I used to rent, and swapping outlets fixed the problem. The Keilini itself draws pretty modest power, so I wouldn’t expect it to be the troublemaker.
17 de August de 2026 at 12:40 in reply to: Anyone using MixMate in an open office? Noise and battery impressions #7336
Susan KennetMemberI keep mine in my bag and use it at my desk most days. The motor is noticeable if the room goes dead quiet, but in a normal office it just blends in. Battery wise I swap the batteries maybe every three weeks or so with daily use. Cleaning is fine, I just rinse it out and run the self clean cycle once a week.
15 de August de 2026 at 20:03 in reply to: Does the JetClean work okay if you just use a bucket? #7238
Susan KennetMemberI’d want the bucket setup to feel effortless before buying, and honestly I’m not sure it would be for me. I’d rather deal with a hose than constantly watch the water level.
-
AuthorPosts
