Forum Replies Created
-
Posts
-
Mine drains the battery faster with the repellent running and the light off, but it still does its thing. I usually just leave the light on the lowest setting anyway, so it’s kind of a moot point for me. Not exactly a nightlight you’d want, but it works.
Gloves haven’t gotten in my way with it, but cold fingers are a different story. The pin comes out fine, it’s getting a grip on the tag itself when my hands are stiff that I notice more.
Sharing just the specific devices is the route I’d take. I did that with a house sitter and it kept the routines untouched since they only had access to the lamps I picked out.
I usually just plug mine in at the hotel and let it check while I’m unpacking. If there’s an update prompt I run it then, otherwise I forget about it until the next trip. It’s been fine so far.
Mine lives outside too and the beading hung on longer than I expected, maybe a month before it started fading. The shine is what I noticed most anyway. Sun’s going to do what it does, but it’s not a waste if you’re after the cosmetic side.
The router does the signing in, so your phone and laptop don’t each need the portal dance. I just open a browser on whichever device and it’s already online. One tip though, put the router somewhere with decent signal, mine dropped the hotel connection when I left it by the window.
Mine sits about a hand’s width from the wall most of the time and it’s been fine. The thing that actually matters for me was making sure nothing soft ends up near the front, since I once had a throw blanket slide a bit too close when I wasn’t looking. I just keep that side clear now. The cord being short is annoying though, so I get why yours ends up wedged back there.
Following the manual to the letter is overkill for a small yard. I’ve had my trimmer for two seasons and just clean the air filter when it looks grimy and top off the oil. Runs fine.
I look at how it feels on my legs after a long run, not the numbers. If it helps me walk normal the next day, it’s good enough for me. The specs never told me anything useful anyway.
Bathrooms honestly aren’t the problem people make them out to be. I’ve had mine in a small bathroom for a while now and the damp air hasn’t caused any issues at all. What actually matters is where you plug it in. I had it on a regular outlet near the sink for a bit and it kept popping the breaker whenever the hair dryer was going too. Moved it to the outlet on the other wall and it’s been completely fine since.
Ten minutes before a shower is nothing. Mine heats up my little bathroom in about that long, and I just unplug it when I’m done. The auto shutoff has kicked in a couple of times when I forgot, so that part works.
I’d say go for it. Just don’t run it on the same circuit as other stuff and you won’t have a problem.
I’ve used mine plugged in plenty of times and it’s been fine, but the thing I noticed is that the heat doesn’t feel as strong when it’s charging. Not sure why, maybe it just pulls less power or something. It still works, just feels a bit milder on the far infrared setting. So if I specifically want the warmth, I usually unplug it and let it run on battery. If I just want the pulse or vibration, I’ll leave it plugged in without thinking twice. No shutdowns or weird behavior either way. Might just be my unit, but that’s been my experience.
Mine just sits on a shelf when I’m not using it, and I’ve only misplaced it once in a few months. The fan buttons are easy enough that losing the remote isn’t a big deal for me.
Keys versus bag is really just about which one you’d actually reach for when your brain goes blank, and for me that’s the bag strap. I keep mine clipped near the top of the strap on a small crossbody I wear most days, mostly because my keys live buried at the bottom of whatever pocket I shoved them into. The one thing I’ve noticed is that where on the bag matters a lot. High up on the strap near my shoulder works fine, but when I had it hanging lower it kept bouncing against my hip while walking and I’d sometimes knock it with my arm. So I moved it up and it stays put. Fumbling isn’t really about the spot, it’s about whether your hand already knows where to go without you thinking about it. If you reach for your bag before your keys anyway, that’s probably your answer.
Rescanning after a small move is the only thing that’s ever made a difference for me. I don’t bother with big shuffles anymore. If the first scan comes up short I just nudge it a few inches and run it again, and sometimes that’s enough to pull in a couple more.
I’ve had mine plugged into a strip near my laundry area for about three months now. Same deal as you, the outlet is tucked behind the washer and a shelf so direct isn’t really practical. It’s a decent strip, not the cheapest one, and nothing has acted up. The green light still comes on, no flickering, no heat that I’ve noticed when I happen to touch it.
What I’d keep in mind is that a strip is only as good as the strip itself. If it’s an old cheap one that already has a bunch of stuff running off it, that’s a different situation than a basic strip with just the StopWatt and maybe a lamp. I don’t think the device cares whether the power comes through a strip or straight from the wall, as long as the connection is solid. If yours has been fine for a month, that’s already a decent sign.
If you actually need the port regularly, the SynGas is just going to be in the way. That part is real. But for me it’s not a hassle because I only plug my scanner in a few times a year anyway. Leaving it in is the whole point of these things.
Mine gets used on two people and a dog in this house, so it’s earned its spot on the counter. The edges come out smooth enough that I stopped keeping a file nearby. I couldn’t tell you how the battery holds up after a year, but so far so good.
The curved mount is actually the one I used. It fits the shape of most helmets better than the flat pad because it can flex a bit when you press it down. I put mine on the front left side of my helmet, held it there for about thirty seconds, then let it sit overnight before riding. That was a few months ago and it has not moved since, even on bumpy paths. The flat pad people keep mentioning seems like it would pop off on a curved shell, so I would not bother with that one. You do not need extra stuff, just clean the spot first and press hard for a bit. Mine came with the sticky base already on the mount, so it was ready to go out of the box. Give the curved one a shot before buying anything else.
The swivel on mine has stayed exactly where I set it. I keep it angled sideways so it clears the shelf above the outlet, and it hasn’t drooped or rotated on its own at all. What I did notice is that it felt a little loose right out of the box too, but that turned out to be the swivel joint itself, not the prongs. The part going into the outlet is solid. It’s been in the same spot for around three months now and I’ve unplugged it maybe twice to move it to another room. Both times it went back in with the same snug fit. So a bit of play when you rotate it doesn’t automatically mean the whole thing is going to work its way out. If the prongs themselves feel loose in the outlet, that’s a different story.
Mine actually did better when I moved it away from the window light. Total darkness didn’t seem to matter as much as not having a brighter light nearby competing with it.
I wouldn’t count on it for sleep, mostly because mine makes a faint clicking sound when the oscillation hits the ends of its swing. That’s the part that kept me awake, not the fan noise. If you leave it pointed in one direction it’s fine.
I’d skip the hub. Mine worked fine for a couple weeks, then the adapter started dropping the wireless link whenever I plugged something else into the same hub. Straight into the car port has been solid ever since.
The stabilizers did feel stiff to me at first, but the bigger issue was the fit. It dug into my thigh when I sat down, so I stopped using it for workouts and just wore it around the house.
My experience has been the opposite of what most people here are describing. I noticed a difference with small stuff right away, and nothing with the big appliances. My husband thinks I’m imagining it but I really don’t think so.
We have an older house and the wiring in the back bedroom is kind of sketchy. Little things plugged in back there used to act up. My bedside lamp would flicker sometimes, and my electric toothbrush charger would get weirdly warm. After we put the StopWatt in, the flickering stopped and the charger doesn’t get hot anymore. That was within the first week or two. So for me it did actually do something for the small electronics, which is kind of the opposite of the usual story.
The fridge and washer? No change that I can tell. They run the same as always. So I don’t think it’s purely about how much power something draws.
I think it depends more on what your wiring is like than on the size of the device. If your place has older or uneven wiring, you might notice it in ways other people don’t. The phone charger running cooler doesn’t sound crazy to me at all.
Mine actually does best in that half-light, so I’d say the dusk thing is overblown. I keep it by the back door and use it most evenings while the dog is out, and that soft gray window before real dark is when the picture looks cleanest to me. Once it’s properly black the image gets that washed out IR look and everything up close blows out. Bats against a pale sky show up as quick dark shapes, which is all I ever wanted from it. I’ve had mine since spring and the battery still holds a few evenings of short use, though I top it up out of habit. I do wonder sometimes if mine just happens to run a little hot on the bright side, so your mileage could vary. Anyway, for standing in the yard at dusk it’s been fine for me.
Traffic probably isn’t the main thing it cares about, but I don’t think it does much when you’re barely moving either. My mileage gains mostly showed up on open road, not in gridlock.
Oil radiators are a different animal. They heat the whole room slowly and keep giving off warmth after you turn them off. The Coolzy is more like a directed warm air thing. Mine takes maybe a minute to start blowing warm air, but it only really helps if you’re sitting near it. It doesn’t warm the whole room the way a radiator does.
For a small office where you’re at a desk most of the time, that’s actually fine. I use mine in a spare room and it takes the chill off pretty fast if I point it at myself. But if you walk out and come back ten minutes later, the room itself isn’t toasty like it would be with the radiator. So it depends what you want. Quick personal warmth, yes. Whole room heat, not really.
