Rivers

Forum Replies Created

Viewing 30 posts - 1 through 30 (of 89 total)
  • Author
    Posts
  • in reply to: Cozy Cove Heater on a timer vs leaving it on low? #17575
    RiversRivers
    Member

    Mine runs on high for maybe ten minutes and the room holds it for a good hour after that, so the on and off fuss isn’t worth it to me. The remote ends up in the couch cushions anyway. Low and done.

    in reply to: Cozy Cove Heater on a shelf instead of wall mount? #17535
    RiversRivers
    Member

    Shelf placement bit me in the ass with a different heater. Warm air rises, and if the shelf sits above where you actually sit, the heat just collects near the ceiling. Mine felt useless until I dropped it lower. How high up is this shelf?

    in reply to: Anyone tried LumaGlasses with an older phone? #17397
    RiversRivers
    Member

    Mine are on an iPhone XR and the audio has been fine. The translation thing is what I’d actually test before keeping them, since it depends on the app more than the glasses.

    in reply to: Qinux FelinStop and heavy rain, anyone had issues? #16939
    RiversRivers
    Member

    Mine’s been outside since March and the one thing I noticed is the solar panel gets grimy fast, which probably matters more than rain. After a heavy storm I wiped it down and the thing perked right back up. I’d leave it out but keep an eye on the panel, rain itself hasn’t killed mine yet.

    in reply to: Does phone navigation still work okay in tunnels? #16617
    RiversRivers
    Member

    I’d just look up the exit before going in and not rely on it in there.

    RiversRivers
    Member

    Those basic meters are useless below a few watts in my experience, the needle just sits there. I ended up borrowing a kill-a-watt style thing from a neighbor and even that was iffy on the really small stuff. Half the junk in my house wasn’t worth the effort of chasing down.

    in reply to: WellHeater on a bathroom counter? #16515
    RiversRivers
    Member

    I’d keep it off the counter. Not because it’ll blow up, but because I don’t want a plug-in heater sitting where water gets splashed and hands reach across. Mine stays on a dry spot away from the sink, and I’m not moving it closer.

    RiversRivers
    Member

    The light switch spot works if that hallway is actually on the path people take. Ours is by the back door where everyone dumps keys and shoes, and the tablet gets checked because you have to walk past it anyway. A spot nobody passes is a dead screen no matter how small it is.

    in reply to: CarbonOne Safe – does it need to be near a window to work? #15288
    RiversRivers
    Member

    Placement matters more than people admit. Mine sat in a spot with dead air and never caught anything until I moved it closer to the actual source. Windows aren’t the issue, but if that kitchen outlet is tucked away somewhere weird, you’re rolling the dice.

    in reply to: Does the Nunawave Oral Care Pro work with a retainer? #14881
    RiversRivers
    Member

    The retainer being in the way isn’t the real issue, it’s that the light isn’t going to do anything through plastic. I’ve tried stacking mine and it was pointless. Just pop it out for the session.

    in reply to: Qinux Zindoggo app on two phones? #14719
    RiversRivers
    Member

    I’d just get a second tracker if you both actually walk the dog separately. Two people logging into one account is fine until you’re both trying to watch the same live session, then someone gets kicked or the map lags. For the money these things cost, that’s not worth the hassle.

    in reply to: WineCork Pro — does it work with slightly wider bottles? #14469
    RiversRivers
    Member

    The WineCork Pro doesn’t care how wide the bottle is, it grabs the cork not the glass. The only thing that changes is how steady you can hold the bottle while it works. If the bottle’s too fat for your hand, that’s your problem, not the opener’s.

    RiversRivers
    Member

    Audio nav through these works fine if you keep the phone on you and the app running. I do it on bike rides all the time and never touch the phone. It’s just basic voice prompts though, so don’t expect anything fancy.

    in reply to: Does the DappSmile LED light actually help you see anything? #14199
    RiversRivers
    Member

    Light works fine for spotting gunk on my front lowers.

    in reply to: Jetterix and low water pressure? #14072
    RiversRivers
    Member

    Mine’s basically a garden ornament unless the tap is wide open, and even then it’s nothing impressive. If your outdoor tap is weak you’re just pushing a slightly more focused trickle around. That’s the whole story.

    in reply to: Does the Dustaclean brush attachment work on sofa cushions? #14028
    RiversRivers
    Member

    Brush is overrated for cushions, mine just fluffs the hair up.

    RiversRivers
    Member

    Mine did nothing for the smell. Ran it for about six weeks and the water still smelled like a pool, so I stopped bothering with it. If the chlorine is heavy enough to notice, a showerhead isn’t going to fix that.

    in reply to: Does MozzDefense work while it’s charging? #13283
    RiversRivers
    Member

    Charging while it runs is fine for the light, but I wouldn’t bother with the repellent side either way. That ultrasonic thing never did anything for me plugged in or not.

    in reply to: Does the CoolCove actually heat as well as it cools? #13243
    RiversRivers
    Member

    Heat mode works but it’s not the same as cooling. I’ve used mine on and off since February and it takes the edge off a cold room, nothing more. If you’re picturing something close to a real heater you’ll be disappointed.

    in reply to: Qinux AirdrobeX how many shirts fit at once? #13174
    RiversRivers
    Member

    Depends on the shirts. Bulky ones eat up space fast, so 4 is about the real limit. Five thin ones might squeeze in but they’ll touch.

    in reply to: Qinux HydroXeltor makes a weird noise, is that normal? #13021
    RiversRivers
    Member

    Squeaks are normal on these. Grinding means something’s wearing.

    in reply to: Keilini Heater Pro: does the rotating plug stay tight? #12573
    RiversRivers
    Member

    Mine’s been plugged in for about two months and the swivel hasn’t let go. It rotates a little too freely for my taste, but the prongs stay seated in the outlet. No slipping so far.

    RiversRivers
    Member

    I used one for about three months last winter, mostly for coffee and the occasional hot chocolate at work. The self-clean thing is real but it is not the magic “walk away” situation the box implies. What actually happens is you fill it with warm water, drop in a bit of soap, hit the button, and the stirring bar does a decent job on the sides and the loose stuff. Then you dump it and you are supposed to rinse. That rinse step is where it falls apart for me. If I only did the cycle and dumped it, the bottom still had a faint film and the lid gasket held onto a smell after a couple days of cocoa. I started pulling the gasket out and rinsing the lid by hand anyway, which kind of defeats the point.

    The bigger issue for me was timing. If I did not run the cycle within maybe an hour of finishing the drink, the dried stuff at the bottom did not come off with just the spin. I had to scrub it with a bottle brush. So it is less a replacement for washing and more a way to loosen things up before you actually wash it.

    Where it did help was protein powder. That stuff clumps and sticks, and the cycle broke it down enough that a quick rinse got it done. So for lighter drinks it is close to what they promise. For anything thick or sugary, not really.

    I still hand wash mine most days. The feature is nice to have but it did not make me less lazy about dishes, which was my whole reason for buying it.

    in reply to: Enence Translator really 1.5 seconds? #12464
    RiversRivers
    Member

    1.5 seconds is a marketing number, not a real world one. Mine does fine with short back and forth stuff, but the second someone rambles it falls apart and I end up repeating myself. That gap adds up fast when you’re actually trying to have a conversation.

    in reply to: WaveMax worth it for a small apartment? #12209
    RiversRivers
    Member

    Depends how close your towers are. If you’re within 25 miles or so, sure, it’ll grab the basics fine. Past that, indoor antennas get flaky and the 120 mile claim is nonsense. Check your address on a coverage map before buying.

    in reply to: PolorVision for daytime driving, does it help with glare? #12059
    RiversRivers
    Member

    Daytime glare is exactly what I bought mine for and I’m not impressed. They dim things a bit but calling it glare reduction is generous. A cheap pair of tinted sunglasses did basically the same thing for a third of the price, so I’d save your money unless you also drive at night.

    in reply to: Does StopWatt help with small electronics or just big appliances? #11926
    RiversRivers
    Member

    The phone charger thing is probably just the phone not pulling as hard once it hits a certain charge level. That happens with or without one of these plugged in. Small stuff draws so little that I doubt you’d ever feel a real difference either way.

    RiversRivers
    Member

    The account is the thing that matters, not the phone. I swapped devices twice with mine and the old weigh-ins were still sitting there once I logged in. Whether that holds if you jump between Android and iOS I couldn’t tell you, but the app itself didn’t wipe anything on me.

    in reply to: WineCork Pro vs my old twist handle, is it really easier? #11112
    RiversRivers
    Member

    Depends what you mean by easier. Less wrist work, sure. But you still have to hold the bottle steady and line the thing up straight, and if you get that off the cork comes out at an angle. The old twist handle let me feel what was happening.

    in reply to: Qinux VultrioX vs the old metal blade head? #10333
    RiversRivers
    Member

    If the current blade setup is working for you, I would not bother switching. The wire thing has its place but it is not some magic upgrade over a metal blade for thick stuff. You are probably better off sticking with what you know unless you are having a specific problem with the blade.

Viewing 30 posts - 1 through 30 (of 89 total)