Leo Grey

Forum Replies Created

Viewing 30 posts - 1 through 30 (of 45 total)
  • Author
    Posts
  • in reply to: Glacier Breeze on a power bank? #16322
    Leo Grey
    Member

    The bigger question is whether the bank can actually supply enough current on startup, since that’s where most of them stumble. I’d check the output rating before trusting it for a couple of hours.

    Leo Grey
    Member

    Freezing isn’t automatically hate. Some dogs just shut down when something feels weird and they need a few sessions to move normally. I’d watch whether she eventually eats or walks with it on before calling it a lost cause.

    in reply to: How do you keep emergency stuff from sliding around the trunk? #16191
    Leo Grey
    Member

    A cheap rubber mat or even a shelf liner under everything stops most of that sliding. I tossed an old yoga mat in my hatch and the cables stay put. Not fancy, but it works.

    Leo Grey
    Member

    A file is what you use out there, full stop. The stone thing is for when you’ve got a bench and time, not for a quick fix mid-job. If your chain dulls fast after filing, you’re probably not getting the angle right or you’re pushing too hard.

    in reply to: Does the Coolizi Coolzy need to stay plugged in all the time #15413
    Leo Grey
    Member

    Settings aren’t the issue. The real question is whether the outlet itself is getting hot. I had a different portable unit a while back and the plug area on the cord got noticeably warm after being left in for long stretches, not the unit itself, the actual plug. Started unplugging it when I wasn’t using it just for that reason. Nothing reset, modes stayed put, no drama. So it’s less about the Coolzy and more about whatever outlet you’ve got it on. If yours stays cool to the touch after a few hours, leaving it in is fine. If it’s warm, that’s your answer. Not saying it’s dangerous, just that I’d rather not push it on an old outlet. The wear on the plug from unplugging daily is a real thing too, so pick whichever annoyance you’d rather deal with.

    in reply to: Does TrimZa actually collect all the nail dust? #15344
    Leo Grey
    Member

    The fine powder is what escapes, not the clippings.

    in reply to: Qinux Vibrathea for shoulder after desk work? #15253
    Leo Grey
    Member

    For me it mostly became a neck and upper back thing, not really a shoulder tool. If I want the shoulder itself addressed I’d rather do a few stretches or use a massage ball against a wall. The device is fine for what it is, but chasing placement on that spot got old fast.

    in reply to: ODIN SafeWave EMF on a white device, does it look weird? #15030
    Leo Grey
    Member

    Visible rectangle on a white tablet is just what it is. Whether that bugs you is personal. I’d care more about whether the thing does anything measurable, and I haven’t seen proof it does.

    in reply to: Qinux Zindoggo app on two phones? #14728
    Leo Grey
    Member

    It works on two phones, but there’s a catch: only one person gets the live alerts at a time unless you both keep the app open. My wife missed a few escape notifications because of that. Fine if you’re just checking location now and then.

    in reply to: Do I need to adjust the Qinux Gravizer for different materials? #14361
    Leo Grey
    Member

    Tips matter way more than the manual admits.

    in reply to: Enence Translator offline mode actually useful? #14219
    Leo Grey
    Member

    I got decent results offline as long as I kept sentences short and simple. Anything with slang or names fell apart, but that’s expected for a device this size. My main gripe is it quietly switches modes and you don’t always notice until it garbles something.

    in reply to: Does the DappSmile LED light actually help you see anything? #14200
    Leo Grey
    Member

    The light isn’t just for looks on mine. I’ve had it a few months and I use it most on my lower back teeth where I can’t see anything without it, it reaches fine there. If yours only works up front, maybe check the angle you’re holding it at, because mine doesn’t fade out like that.

    in reply to: WaveMax channel scan keeps missing channels? #13929
    Leo Grey
    Member

    Moving it around is fine but check your TV’s tuner menu first. Some sets have a separate option for “add channels” versus a full rescan, and if you’re just hitting the same scan button you might be skipping the weaker ones. Mine picked up a few extras once I switched to the full reset scan instead.

    in reply to: Does the SleepZee need to be replaced often? #13913
    Leo Grey
    Member

    No clue what the real lifespan is. Mine has held up around five months so far with nightly use and it still fits the same. I figure once the bite starts feeling loose or it warps, that’s when I’d swap it.

    in reply to: How do you actually position the MrBold Pro for ear hair? #13601
    Leo Grey
    Member

    I tried circles and it did basically nothing for me. Going straight in didn’t feel like it grabbed much either. What actually worked was doing several slow passes from a couple different directions. Still not convinced it gets everything, but good enough.

    in reply to: Does Translattia fit small ears okay? #12776
    Leo Grey
    Member

    Small ears here, foam tips are a must for me.

    in reply to: Does the Clima Pest Guard need to be the only light on? #12466
    Leo Grey
    Member

    A bit of light is fine, but I don’t buy that it never matters. Mine sat in a room with a bright porch light outside and caught almost nothing until I started drawing the blinds. Not saying it needs pitch black, but acting like brightness is irrelevant doesn’t match what I saw.

    in reply to: ChirpyCharm vs my old feeder: how much bird activity is normal? #12333
    Leo Grey
    Member

    Notifications got old fast, I left mine off.

    in reply to: Does ODIN SafeWave EMF work on routers that are behind a cabinet? #12197
    Leo Grey
    Member

    Everyone’s overcomplicating this. A wooden cabinet doesn’t block a passive sticker any more than the router’s own plastic shell does, so placement barely matters. Mine’s been on a router in a closed cabinet for months and nothing changed either way.

    in reply to: Heater Pro X for a chilly home office? #11420
    Leo Grey
    Member

    Calling it a gimmick misses the point. These little plug-in units are basically personal heaters, and if you expect actual room heating you’ll be disappointed. For warming your hands and face at a desk it’s fine, for anything beyond that I wouldn’t bother.

    in reply to: Omnihear for one-on-one chats? #11287
    Leo Grey
    Member

    Fair enough, sounds like I was overcomplicating it. I’ll just leave it on one mode and stop fiddling with the buttons. Volume only, got it.

    in reply to: Qinux Pixgo 4K waterproof case question #11044
    Leo Grey
    Member

    Depends where you buy it. Some sellers ship the case in the box, others sell it as a separate add-on. I’d check the specific listing before ordering instead of assuming.

    in reply to: Qinux BitBip 89 – can I add my own games easily? #10902
    Leo Grey
    Member

    Adding games is possible but “not super techy” and “won’t mess anything up” don’t really go together here. You’re basically copying files onto the storage and hoping the menu picks them up. If you stick to common retro formats it’s usually fine, but I wouldn’t call it plug and play.

    in reply to: Does MixMate work for matcha or just coffee? #10867
    Leo Grey
    Member

    Matcha still clumps for me, coffee only.

    in reply to: How does the Pro Capture handle shadows in bright sun? #10775
    Leo Grey
    Member

    I’ve had a Pro Capture for about six months and stopped fighting the shadows. The footage is what it is, and messing with settings just trades one problem for another.

    in reply to: Flixy stick and 5GHz wifi, does it matter? #10709
    Leo Grey
    Member

    I wouldn’t touch the router settings for this. I’ve got a similar stick setup in my basement and just left it on whatever band it grabbed. The drops I get are usually when someone else is hammering the network, not from the band itself. If yours is anything like mine, the stick probably doesn’t even pick the better band on its own. So you could go in and split the bands and force it, but then you’re messing with every other device too. I did that once for a different reason and spent an hour getting my printer back online. Not worth it for a couple seconds of buffering. If it’s genuinely annoying you, maybe try it, but I’d leave it alone unless it gets worse.

    in reply to: Does the Melara Air really work for all sleeping positions? #10691
    Leo Grey
    Member

    Fixed pillows always claim that. My take is if you actually rotate between all three, you’re compromising somewhere, and the stomach position is usually where it shows. I’d want a return window before dropping money on one of these.

    in reply to: WaveMax without a window? #10526
    Leo Grey
    Member

    No window here either. Mine’s been on a shelf since I got it and it does fine for the local stuff. Doesn’t pull in everything, but it’s not dead weight.

    in reply to: AiraBreeze in a room with a ceiling fan? #10454
    Leo Grey
    Member

    Fans push the cool air away from where you actually are, so keeping both on just cancels out the point of the cooler. I’d pick one. If the fan is doing the work you want, the AiraBreeze isn’t adding much on top of it.

    in reply to: Does the Qinux Klampero work on older chains or just new ones? #9674
    Leo Grey
    Member

    The whole “older vs newer” thing is overblown. I ran mine on a chain that had already been filed down unevenly by hand and it still cut fine afterward. It won’t fix a chain that’s stretched out or has damaged teeth, but if it’s just dull, age doesn’t matter much.

Viewing 30 posts - 1 through 30 (of 45 total)