Forum Replies Created
-
Posts
-
Polished quartz makes sense for that. My sister has quartz in her kitchen and I’ve watched a plastic bowl scoot across it just from setting it down a little crooked. That surface is slick by nature, so the board being light definitely doesn’t help. I still think you’re onto something with the rushing too, since mine settled down once I slowed my cuts. If you’re not into the towel idea, maybe try it on a different spot on the counter first, like nearer the edge or wherever the finish feels less glassy, just to see if it behaves differently. Not really a fix, more like a way to confirm it’s the counter doing it and not the board. Either way I wouldn’t swap back to a heavy wood block over it. The drying and smell thing got old for me way faster than a little sliding ever did.
Mine has been fine on a painted wood table but that table is dead flat and nothing really slides on it. I did try it once on a slightly warped folding table at a family thing and it wandered a little, though that table is uneven anyway so I kind of expected it. What I noticed is the board is pretty light, so a heavier board is less likely to shift. I grew up with a thick wood block that weighed a ton and never moved, but it also took forever to dry and started smelling if I left it wet. So I actually prefer the lighter board now and just accept that it can slide on some surfaces. I have not tried the towel thing because I do not like the idea of a wet cloth sitting under it while I am prepping meat. That is more of a personal hang up than anything. If yours is moving on a normal flat counter, maybe give it a few more weeks and see if it settles. Mine seemed to stop sliding once I stopped rushing the cuts. What kind of counter do you have it on?
A screen is not suddenly going to fix a weak projector. Dim is dim no matter what you point it at, and I would rather put that money toward a brighter unit than a surface that cannot add light. Mine looked about the same on fabric as it did on a plain wall.
One might be enough if you place it right where you sit rather than trying to cover the whole balcony. I’ve used a similar UV thing on a porch and it handled the bugs near the seating fine, the far corner not so much. Doesn’t need to be a whole-balcony setup to be useful.
Mine does the same thing, but I don’t think it’s just a bad gauge. The light drops quick then hangs around forever, and I get way less than the rated run time when I’m on the trigger hard. If it still blows strong for you then fine, but don’t trust the bars to tell you when you’re actually low.
I haven’t tried anything thinner than that squash soup, so I can’t say if broth would treat the lid any better. Mine was just the one attempt and the seal loosening showed up after maybe three or four uses with it. That was enough for me to stop putting soup in there.
I don’t think it’ll leave streaks as long as you keep moving and don’t let the soap dry on there. The main thing is it’s still just a hose nozzle, so don’t expect it to blast suds off like a pressure washer. Mine helps enough that I stopped dragging the bucket out every time.
The cable matters more than people think. I tried a short one I had lying around and the cooler kept cutting out, swapped to a thicker charging cable and it ran fine for the couple hours I needed.
Placement is the whole ballgame with these things. Mine is set up in the hallway and it still catches my dog when he wanders into the kitchen, so a fixed spot can cover more than you’d think. I just leave it be and it does its job.
I actually like the short windows. If a place gives me 14 days, it forces me to actually test the thing instead of letting it sit in the box for a month. I set a reminder for day 10 and that’s it.
A divider actually did help me a bit when I had one set up a couple feet in from the window. Not because it blocks the sound exactly, it just breaks up that direct line so the cars feel further away. It wasn’t a huge change, but it took the edge off enough that I kept it there.
I’ve used mine for a few mobile games and the sound stayed pretty much in sync with what was on screen. No clue if that counts as a real low latency feature or just how it happens to work with my phone, but it felt fine to me.
One bad reading doesn’t mean much to me either way. I still look at the week as a whole because a single night can get thrown off by something random and then it’s back to normal the next day. Your husband might have a point but I get why you’d still check.
I’ve got one in my spare room and the noise is honestly the least interesting thing about it. What actually bugs me is the beep when you change settings on the remote. It’s loud enough that I mute it before bed, and there’s no obvious way to kill it permanently. The fan itself I stopped noticing after the first week, but that little chirp still gets me if I’m messing with the temp at 2am. I came from an old box fan that rattled, so the CoolCove is a step up in that department. If you’re the type who wakes up to random beeps but can tune out a steady fan, this thing will probably be fine. If it’s the opposite, you might want to hear it in person first.
Mine’s been up since spring and I’ve never seen a bird react to the night mode. They look at the camera because it’s sitting right where the food is, not because of any light. If they were actually bothered they’d stop showing up, and mine come back every night.
My setup is the same and I just charge from a little 12v plug I had lying around, works fine while the adapter stays put in the USB. The wireless thing was the whole point for me, so losing the cable wasn’t a dealbreaker. Adapter’s been solid for a few months now.
The 120 sq ft number is probably measured in a perfect empty room with nothing in it. I had a similar deal years ago with one of those old school plug in things, forget the brand, and it worked okay in a kitchen but that was a pretty open space. In my current place I tried one in a hallway thinking it would cover the rooms off it and that did basically nothing. The sound just doesn’t carry like you’d hope once there’s a wall involved. I think of it more like a lamp. It lights up the area around it fine but you wouldn’t expect one lamp to light your whole apartment. So if you’ve got a few rooms, one unit is probably going to disappoint you unless you’re only really worried about whatever room you plug it into.
Soft surfaces mess with the handle part more than the feet in my experience. I tried mine on a padded mat once and the upper body readings were all over the place, weight was fine though. If you actually want the full scan numbers to mean anything, hard floor is the way.
Mine does something similar but it’s more of a gradual shift than a washout. Takes a few seconds to settle back to normal colors. I just figured that’s the sensor catching up after the IR cuts off.
Mine still has a faint line after about six weeks, but it only shows up when the projector is really bright. I hang mine from the grommets and leave it up most of the time, which helped more than anything I did with the bag. Rolling is easier on it than folding, but I doubt it gets rid of a crease that’s already set in.
Mine stays put, but the swivel has a bit of play in it right out of the box. I’ve had it hanging sideways off a wall outlet for a few weeks and it hasn’t moved from where I set it. That little wobble seems to just be how these rotating plugs feel.
I’ve used those old-school fridge boxes with the charcoal stuff for years, so I get the appeal of something rechargeable that skips the filter hassle. On the always-on question, I kind of see it like a ceiling fan in a stuffy room. You can flip it on after things get bad, but by then you’re just chasing the smell around instead of it never building up in the first place. That said, I don’t think it needs to run 24/7 to be worth having. Tossing it in for a few hours after a grocery run or when leftovers sit a bit too long feels more realistic than leaving it humming forever. The no-filter part is what actually got my attention, since I always forgot to swap the baking soda box anyway. Whether it beats plain old baking soda is the real question for me.
