Mike Casio

Forum Replies Created

Viewing 26 posts - 1 through 26 (of 40 total)
  • Author
    Posts
  • in reply to: Does the Ozoori need to be on all the time to work? #12093
    Mike Casio
    Member

    Probably on all the time or it’s pointless.

    Mike Casio
    Member

    Faster warmup doesn’t mean better heat. My radiator is slow but the room actually stays warm. Quick heat that fades in ten minutes is useless.

    in reply to: Does the ClairLite remote work through a wall? #11529
    Mike Casio
    Member

    I’ve only used mine in the same room, but the remote has been fine for that. Buttons are a bit mushy though, so you have to press pretty hard.

    in reply to: Vanotium board vs old plastic one for raw chicken? #11464
    Mike Casio
    Member

    That was quick, thanks for the replies everyone.

    in reply to: Does Back Restore actually need 15 minutes or can I do less? #10868
    Mike Casio
    Member

    10 minutes did nothing for me, 15 barely helped.

    in reply to: Does Glacier Breeze need distilled water or is tap water fine? #10583
    Mike Casio
    Member

    Tap water is fine, but it depends on how hard your water is. I ran tap in mine for about two months and the pads turned crusty and stiff. Not clogged exactly, but they stopped absorbing water the way they should, so cooling got weaker. I didn’t notice until I pulled the pad out and it felt like cardboard. Swapped in a new pad and started using bottled water from the grocery store, and it stayed soft way longer. Distilled isn’t some scam, it does make a difference over time, but you’re not going to kill the thing overnight with tap. If your water is soft already you might never have an issue. Mine is hard as a rock, so that’s probably why it got bad so fast.

    in reply to: ODIN SafeWave EMF on earbud case, does it fit okay? #10460
    Mike Casio
    Member

    I’d skip it on a case that small.

    Mike Casio
    Member

    I don’t get the space worry honestly. I’ve got one sitting in a pretty cramped fridge and it’s not the thing taking up room, it’s the random jars and leftovers that pile up. The unit itself is maybe the size of a small coffee mug, it just sits on a shelf or in the door bin and doesn’t interfere with anything.

    I think people overestimate how big it is because they picture some clunky air purifier. It’s not. I shove mine next to the butter and it’s been fine for a couple months now. If your fridge is so packed that this little thing gets in the way, you’ve got a different problem.

    Mike Casio
    Member

    Different devices take readings under completely different conditions. Your watch is sitting on your wrist all day, your scale only measures for the few seconds you’re standing on it. Of course they won’t match perfectly.

    What I noticed with mine is that it depends heavily on when I step on. Morning before coffee gives me one number, after dinner gives me another. Neither matches my watch at those times.

    I wouldn’t lose sleep over it. The scale is giving you a snapshot, the watch is giving you a trend. If the difference is always around the same amount, that’s probably just the baseline offset between the two sensors. If it’s jumping all over the place randomly, then maybe there’s something off.

    Mine has been consistent enough to track the direction my resting heart rate is moving, which is all I really need from it.

    in reply to: NanoPolix actually safe on clear coat or just marketing? #10133
    Mike Casio
    Member

    I wouldn’t trust it on anything you care about for months of regular use. I grabbed one to clean up some marks on my wife’s SUV and it worked okay the first few times. Then I got lazy and used it on a dirty panel without washing it first. That was on me I guess, but it left those little spiderweb marks that you only see in direct sunlight. Nothing terrible, but it wasn’t there before.

    Anything that’s removing scratches is basically sanding down the clear coat. A cloth doesn’t change that. It’s just a finer grit than a machine polish. Fine for an occasional touch up but if you’re using it every month you’re slowly thinning the clear coat. I only break mine out now when something really needs it and the paint is clean.

    in reply to: Best spot to plug in Heater Pro X in a drafty room? #9728
    Mike Casio
    Member

    If you can feel the draft sitting at your desk, that cold air is going to keep washing over you no matter where the heater is. I had mine plugged in near the window in my old place and it was basically a waste of electricity. The unit kept kicking on and off, trying to keep up with air that was colder than the thermostat setting, and I still had cold shoulders.

    I moved it to the outlet on the wall next to my chair, not pointed at my face, just angled out into the room. It stopped fighting the draft and actually made the air around me feel warmer. The window area still feels chilly if I walk over there, but I stopped caring because I am not standing by the window. I am sitting at my desk. Put it where you sit, not where the cold comes in. That draft is a separate problem you fix with weather stripping, not a space heater.

    in reply to: Black Falcon Drone setup time – is it really quick? #9467
    Mike Casio
    Member

    Good to hear it’s not just me being impatient. I was expecting some annoying calibration ritual every time. Sounds like once you get past the initial app stuff it’s pretty much just unfold and go. Might actually pull the trigger on it.

    in reply to: Does the CoolJet need ice to work well or is water enough? #8355
    Mike Casio
    Member

    Ice is a pain to deal with every morning, but yeah, there’s a real difference. Water alone just feels like a weak fan blowing slightly damp air at you. I tried skipping the ice for a week and ended up going back. If you’re not willing to do the ice thing, I’d say skip this and get a regular fan.

    in reply to: Coolizi Coolzy noise level in heating mode? #8298
    Mike Casio
    Member

    Heating mode is definitely not as quiet as cooling. It’s got a louder hum that you notice at night, especially when you’re trying to sleep. I was surprised by it honestly, but it’s not unbearable. Just don’t expect the same whisper quiet.

    in reply to: Does the Nunawave Oral Care Pro feel bulky in your mouth? #8086
    Mike Casio
    Member

    I tried it once and yeah, it’s noticeable. If you’ve got a small mouth, you’re probably going to feel like you’re holding something in there the whole time. Not painful, just annoying after a couple minutes. I didn’t bother using it much after that.

    in reply to: Does the Epicooler make sense for a small bedroom in a rental? #7844
    Mike Casio
    Member

    If you’re renting, I get it, but I’d still skip it. It’s just a fancy fan with a heater bolted on. It’ll take the edge off if you’re sitting right next to it, but the rest of the room will stay stuffy. Not worth the floor space.

    in reply to: Does the Qinux WarmPro make the room feel stuffy after a while? #7498
    Mike Casio
    Member

    I run mine for most of the evening and I get that same heavy feeling. It’s not a dealbreaker, but the air definitely feels less fresh after a couple hours. I just turn it off for a bit when it gets to that point.

    Mike Casio
    Member

    Step counting on these things is a rough estimate at best. Mine has days where it feels generous and other days where it barely moves unless I’m actually walking outside. I wouldn’t put too much stock in the exact number, just use it for a general idea.

    in reply to: SleepZee fit after a few weeks, does it loosen up? #7117
    Mike Casio
    Member

    Mine stayed tight. I gave up waiting for it to break in and just dealt with it. If yours feels like it’s squeezing you awake, that’s probably your answer.

    in reply to: ODIN SafeWave EMF on a smart TV, any reason not to? #7042
    Mike Casio
    Member

    Stuck mine on a few months back, still there. Good enough for me.

    in reply to: Qinux BarkBuz on a puppy, too early or fine? #6924
    Mike Casio
    Member

    Honestly it’s probably fine if the dog is old enough to react to it at all. My pup was around four months and it didn’t cause any issues, but I also didn’t rely on it as the main training tool. It just took the edge off. If you’re seeing results already, I wouldn’t overthink it.

    in reply to: Does the CoolJet actually help much on really humid days? #6657
    Mike Casio
    Member

    I was in the same boat when I first got mine. The whole evaporative thing sounded like a gimmick to me, but I figured whatever, it’s a fan with a tank, how bad could it be. On the muggy days I actually kept using it just because it was already sitting there on my desk, and honestly, I stopped expecting the ice to do anything. It doesn’t.

    But here’s the thing. I noticed pretty fast that it still feels better than a plain fan. The air just feels less dead, if that makes sense. A regular fan just pushes the same sticky soup at you. This one at least makes the air around your face feel like it’s moving somewhere, not just bouncing off the wall. I don’t know if the humidity actually drops or if it’s just the water in the tank doing something, but I stopped caring about the science of it.

    I’ll say this though, I don’t bother with ice on those days. It melts in half an hour and then you’ve got lukewarm water doing nothing. I just fill it with cold tap water and run it on the higher speed. That combination still beats nothing when the air is gross. You won’t get that arctic blast you get on a dry day, but you also won’t feel like you wasted your money. It’s still more than a fan, just not by a mile. Keep it running, skip the ice, and you’ll be fine.

    Mike Casio
    Member

    Took me a while to even bother with this thing honestly. I was pretty sure it was going to be another one of those gadgets that looks good on a screen and then feels cheap in your hand. But after having it around for a bit, I’ve changed my tune a little.

    I’m not going to pretend I did a bunch of research or measured my dog’s neck or anything like that. I just put it on and adjusted it until it looked right. For a 20 kg dog, I really don’t think you’re going to have a problem with the strap itself. There’s enough room to make it snug without it being a whole production. The part that sits against the neck is a bit chunky, but it didn’t seem to bother my dog much after the first few minutes. He stopped noticing it pretty quick.

    The daily wear part was my main worry too. I don’t leave it on all day, just for training sessions and when we’re out in the yard. But it didn’t rub or cause any redness in the short time I used it. For the price and what it does, it’s been fine. I wouldn’t say it’s amazing, but it’s not the flimsy piece of junk I thought it was going to be when I ordered it. I guess I was wrong about that part.

    in reply to: PestVault vs. the old peppermint spray I used to buy? #6399
    Mike Casio
    Member

    I never got why people are so hung up on the spray vs pouch thing. One’s a chore, the other isn’t. If you’re the type who actually remembers to reapply stuff, stick with what you got. If not, pouch wins by default.

    in reply to: StopWatt and older wiring, anyone tried it? #5837
    Mike Casio
    Member

    Old wiring or new, it’s still just plugging a box into the wall. I doubt the copper cares how old it is.

    Mike Casio
    Member

    I get about 5 days out of mine and that’s with all the tracking stuff on. 6 days is probably if you barely look at it. Not a big deal, still lasts long enough.

Viewing 26 posts - 1 through 26 (of 40 total)