Jordan Writes

Forum Replies Created

Viewing 30 posts - 1 through 30 (of 64 total)
  • Author
    Posts
  • in reply to: Black Falcon Drone: how do you frame shots without a gimbal? #17595

    Panning smoothly is just harder on these little drones.

    in reply to: Herz P1 Smart Ring comfortable enough for side sleepers? #17285

    Ring finger makes sense then. That’s actually where I ended up too, and the sensor bump sits in a spot that doesn’t press into anything when my hand’s flat on the bed. Give it a few nights before you judge it, the first one always feels odd just because it’s new.

    in reply to: Herz P1 Smart Ring comfortable enough for side sleepers? #17250

    Mine has been fine for side sleeping, but I did notice it more when I wore it on my index finger and less after I moved it to a different finger. The sensor bump was what I felt, not the ring itself. It’s easy to forget once you settle in. Which finger are you planning to wear it on?

    in reply to: DappSmile making my gums feel weird after use? #17083

    Mine does the same thing on soft mode, usually fades by the time I finish my coffee. I still use it a few times a week and the tingle has gotten less noticeable the longer I’ve had it. Could just be your gums getting used to the vibration.

    in reply to: Does the Melara Air actually stay cool or just less hot? #16810

    The cooling part isn’t going to feel like a cold pillow if that’s what you’re picturing, but mine does feel noticeably different from a regular foam one. I tend to run hot too and I’m not waking up to flip it as much, which was the main thing I wanted. It’s more that it stays neutral instead of turning into a heat trap.

    Magnets in bag clasps are not doing anything to your Guardality. I’ve had mine in a messenger bag with a big magnetic flap closure since last winter and it’s been totally fine. The blocking layer inside the card isn’t affected by a little magnet holding your bag shut. If magnets actually killed RFID shielding then half the wallets on the market would be useless overnight.

    I get why people ask though. It sounds like it should matter. But in practice it just doesn’t. Mine sits right next to the clasp when the bag is closed and I’ve never had a single weird moment with it. Cards still get blocked the same way they always did.

    The only thing I’d actually pay attention to is whether your cards are physically close to the Guardality card. That’s what makes the difference, not some magnet on the outside of the bag. Keep them together in the same pocket and you’re set.

    in reply to: Is it safe to use old tool batteries for a DIY power bank? #15603

    I did basically that with an old Ridgid pack and it ran my phone all weekend at the lake with no trouble. I just wired it to a USB car charger and rolled with it. Phone charged fine every time, never got hot or weird on me.

    in reply to: Does StopWatt work if I only plug it in at night? #15592

    I tried unplugging mine during the day for a while and honestly the green light was still on at night so it’s doing something, but I ended up just leaving it in anyway. Plugging and unplugging it constantly got annoying fast. If you’re only doing nights I’d say just pick one outlet and stick with it.

    in reply to: How do you know if your wellness device data is actually useful? #15346

    The way I look at it, the question isn’t really how much data a device gives you, it’s whether you’d actually do anything different based on it. That’s the only test that matters for me.

    I had a stretch where I was checking my sleep numbers every single morning, and after a couple months I realized I was basically reading the same story over and over. Bad night, tired. Good night, fine. The number never told me anything my body hadn’t already told me before I even got out of bed. So all that extra detail was just sitting there looking impressive.

    The stuff that actually changed my behavior was the boring stuff. Step count, because it nudges me to take a walk I otherwise wouldn’t. That’s it. Everything else was entertainment.

    So when you’re eyeing an upgrade, I’d ask whether there’s a specific thing you’d do differently with the new numbers. If you can’t name it, it’s probably noise.

    I’ve had good luck just adding stabilizer to the can before the last mow or two of the season, then parking it like normal. The mower sat for about five months last year and fired up on the first pull in spring. That’s easier for me than trying to run it dry and fuss with it later.

    in reply to: ChirpyCharm camera at night, does it spook the birds? #14013

    I’ve had mine running since late spring and I can say the birds around my place seem completely unbothered by the night mode. What I’ve noticed instead is that it’s the sudden motion of the camera itself, not the light, that gets a reaction. When a bird lands and the feeder shifts just slightly on the bracket, that tiny movement is what makes them pause and look. The infrared has been a total non issue in my yard, even with the regulars that show up every evening around the same time. They just hop on, grab a bite, and settle in like nothing is happening. I actually get some of my clearest clips after dark because the birds seem calmer without all the daytime activity going on around them. So from my experience, whatever they’re doing with their heads, it’s not the camera sending them off.

    in reply to: Does PestVault work in an RV that sits for weeks? #13296

    I’d ignore the whole “they’re done after a couple weeks” thing and just go by whether you still catch a whiff when you open the door after a hot stretch. My parents leave a couple in their camper that sits most of the summer, and they only bother replacing them when the smell fades, not on a calendar. If yours are still noticeable, they’re still doing their job.

    in reply to: Qinux HydroXeltor makes a weird noise, is that normal? #13006

    Mine only acts up if I leave it connected with the tap still on, then the first squeeze gets a little chirp before it settles. I started shutting the water off between uses and it mostly stopped. Could just be trapped pressure somewhere in the line.

    in reply to: Flixy vs old Roku stick, is the remote lag annoying? #12419

    I don’t think the lag is something that just goes away with updates, at least not in my case. I’ve had mine since spring and the remote still has that slight delay when I’m moving around menus, though it’s never bad enough to actually bother me. Coming from an older stick you’ll probably notice it more at first, but I stopped caring after a while. It’s just how this one feels.

    in reply to: WaveMax worth it for a small apartment? #12203

    I’d grab one if I were you. Mine pulls in the basic locals fine and I don’t miss paying for cable one bit. Worst case you’re out a few bucks and you still have your streaming stuff.

    in reply to: Derila Ergo too low for side sleeping? #12169

    I actually prefer mine a little lower.

    in reply to: Matsato blade vs my old knife, is the finger hole a big change? #11981

    Mine stopped feeling odd around the second week, but I think it was mostly because I quit thinking about it and just cooked. If you’re actively noticing it every time you pick the knife up, that’s a different thing. I’d give it a few more meals before deciding.

    in reply to: Does StopWatt help with small electronics or just big appliances? #11929

    Small electronics are actually where I noticed it most. My little rechargeable toothbrush used to take forever to charge and after a few weeks it seemed to top off faster. Could be the unit, could be the toothbrush getting older, but I’m keeping it plugged in either way.

    in reply to: Qinux Talkbuds for watching foreign movies? #11792

    I mostly use mine for movies and shows and they work great for that. People keep saying they’re only good for face to face stuff but I’ve watched a bunch of Korean dramas with them and had no trouble following along.

    in reply to: SynGas and stop-start traffic, does it help there? #11743

    Fair enough, I’ll just keep letting it do its thing.

    in reply to: Qinux Klampero and left handed use? #11372

    I’ve had mine for about a month and the lefty thing mostly faded once I stopped choking up on it so much. Grip it a bit further back and it sits straighter in your hand. Could just be me though, I’m not exactly gentle with my gear.

    in reply to: Omnihear for one-on-one chats? #11243

    I’d just leave it in quiet mode for that kind of setting and not touch it. That’s basically what I do when it’s just me and one other person in a normal room, and I quit fiddling with modes weeks ago. Two people talking is the easy case for mine.

    in reply to: Breezi AC noise level actually quiet at night? #11219

    Mine’s on my nightstand and I stopped noticing it after a couple weeks, but I also run a floor fan in the hall so there’s always some background noise in my place. Total silence would probably be a different story. If you truly need dead quiet, I don’t think any little fan is going to disappear completely.

    in reply to: DappSmile tips vs old metal pick? #10837

    A metal pick only does what your hand does, which is scrape. The DappSmile tips vibrate, so they knock stuff loose instead of you having to chip at it forever. That’s a real difference, not just a fancier handle. I’ve had mine about four months and I still reach for it over the old pick.

    in reply to: Does SavingStars work if I have a septic system? #10711

    I’ve been running SavingStars through our house for close to a year now, probably once a month on the tub drain, and our septic has been totally fine. Had it pumped in the fall and the guy didn’t say a word about it. The powder thing isn’t really the point, it’s more about not dumping a whole container every week.

    in reply to: Does Glacier Breeze need distilled water or is tap water fine? #10545

    Tap water has worked fine in mine for about four months now. I just dump whatever’s in the sink, run it a few times a week, and nothing’s clogged up or smelled weird. A quick rinse every so often seems to handle any buildup before it becomes a thing. Maybe it shortens the life somewhere down the road but I haven’t seen it yet.

    in reply to: WaveMax without a window? #10493

    Mine sits on a bookshelf nowhere near a window and I still pull in all my local channels fine. Took a bit of fiddling with where exactly I set it, but once it locked in it stayed put. Worth a shot in your place before you start hauling stuff into the kitchen.

    in reply to: Qinux BarkBuz battery life after a few weeks? #10427

    I actually get closer to ten days on a charge, but I only switch mine on when the barking starts. Leaving it running all day is probably what’s eating your battery, not some defect.

    in reply to: Qinux VultrioX vs the old metal blade head? #10320

    I think the VultrioX is worth grabbing if you’re tired of stopping to sharpen or replace stuff. I used mine mostly on rocky patches and fence lines where I used to worry about the blade sparking or kicking things up. It chewed through the overgrowth fine, though I did notice it takes a bit longer on really thick stems.

    in reply to: Does SynGas need a certain spot in the car to work well? #10028

    I keep mine shoved in a spot where I can barely reach it and it’s been running for months without a hiccup. The learning process doesn’t care about angles or how tidy it looks. As long as it’s actually plugged in and making contact, you’re good.

Viewing 30 posts - 1 through 30 (of 64 total)