Does the Qinux Vapoxis work okay on oven glass?

I’ve used mine on the oven glass a few times now, mostly on the inside of the door and the panel above the stovetop. It’s been fine so far. I just make sure to wipe the glass down with a dry cloth right after steaming so it doesn’t leave streaks or water spots. The heat hasn’t caused any cracks or anything like that on my oven, and I’ve done it maybe four or five times now. I think the main thing is not to hold the steam in one spot for too long, but that’s probably true for any surface. I’d say keep using it if it’s working, just don’t go overboard with how long you blast the same area.

Glass is glass, steam is steam. I don’t see why it would be an issue as long as you’re not blasting the same spot for ten minutes straight. The heat from the oven isn’t going to do anything to it either since it’s already hot when you’re using it. You’re fine.

It’s fine on oven glass, I’ve used mine on the door and the sides without a problem. Just don’t hold it in one spot too long or you’ll end up wiping streaks anyway. I think people worry about it more than they need to.

Oven glass is tempered for a reason, it takes way more abuse than a bit of steam. I have used mine on the door glass a few times and it was fine, no streaks or cracks left behind. The only thing I would say is just keep the nozzle moving and don’t let the heat build up on one spot for too long.

I actually had a slightly different experience with mine on the oven glass. It cleaned fine, no argument there, but I noticed if I wasn’t moving it around enough, it left those little water spots that dried into streaks. Took a bit of extra buffing with a dry cloth to get it looking clear again. Not a big deal, but the glass on the oven door seems to show that more than the countertops or bathroom tiles do.

People worry too much about steam and glass, it’s not going to crack from a few passes.

It’s a fair thing to wonder about, but I don’t think the steam itself is the risk. The heat from the oven is way higher than what that thing puts out. I’ve done my door a couple of times and it’s been fine, just keep moving the nozzle so you don’t leave it sitting on one spot too long.

Used mine on the oven glass a few times now and it was fine. No streaks left behind once I wiped it off. I wouldn’t say it’s the best surface for it, but it definitely gets the job done without damaging anything.

I’ve used mine on the oven glass a few times without any real issues. The steam does the job on the grime. I just wipe it down after and it’s been fine. Not sure why people think it’s some risky surface.