Qinux Vapoxis for car interior? Anyone tried it?

I’d stick to the hard surfaces in the car.

Steam on car seats is a bad idea, period. I tried it on an old beater I didn’t care about and the fabric got damp way down into the foam, took two days to dry out. Dash and vents are fine, but I’d keep it off upholstery.

Mine just pushed the grime around on my seats.

Mine did fine on my seats but I didn’t go crazy with it. Biggest thing I noticed was they dried pretty quick since it’s steam and not soaking wet. Just did a pass, wiped, and moved on.

I’m really picky about keeping the fabric in my car looking decent, so I tried the Vapoxis on a small section of my back seat before doing the whole thing. It actually pulled up a decent amount of the lighter grime, but you have to use it in short bursts. If I held it in one spot for too long the fabric got pretty warm and damp. I just went over it with a clean towel right after and let the windows down for a while. For me the tradeoff is worth it since I don’t have to use any chemicals near where my dog rides. I keep a towel handy and don’t rush it. That’s really all I do.

I haven’t tried mine on seats yet, mostly because I’m nervous about the fabric, but I did use it on the carpeted floor mats and that part went surprisingly well. The mats had that gross winter salt and soda situation going on, and the steam lifted a lot of it without soaking everything. What surprised me was how fast they dried compared to when I normally scrub them with a wet cloth. That said, I did notice the mats got a little stiff feeling after they dried, which I didn’t expect. Not ruined or anything, just kind of crunchy until I vacuumed them again. I keep going back and forth on whether I’d risk the actual seats. The mats are replaceable, the seats are not. I’d probably test a spot under the seat where nobody sees it first if I were you. Still on the fence about whether this thing is really meant for car interiors or if people are just making it work.

Seats are fine if you keep the head moving. I’ve done my cloth back seat twice now and the fabric came out looking normal, no shrinkage or water rings. The part people get wrong is parking the nozzle in one spot and letting the steam soak through. That’s when you get the smearing some folks are mentioning. Short passes, keep it moving, and it lifts the surface grime fine. Dashboard is a different material though, so I wouldn’t lump the two together. Plastic and vinyl react differently than cloth. If you’re just worried about the seats, I’d say go ahead. Just don’t expect it to pull out old set-in stains. It gets the top layer and freshens things up, which was enough for what I needed.

I only use mine for hard surfaces, so I can’t say much about fabric seats. Where it did help was the plastic trim around the door panels. It lifted out that sticky buildup without leaving any marks, and I didn’t have to scrub much. I’d still test a hidden spot first if I were you.