Mounting the Qinux ScryneX on a brick wall – any tips?

I’d just use masonry anchors and a decent drill bit. It’s not rocket science, just make sure you don’t crack the brick. The screen itself is light enough that it shouldn’t be a problem.

Honestly, I wouldn’t overthink the brick part. Just make sure your drill bit is sharp and you’re not using some cheap hardware store anchors that’ll crumble. The screen’s light enough, so it’s not like you’re hanging a boulder.

Oh nice, a brick wall setup sounds pretty solid honestly. I’d probably go for it, the screen is light enough that you don’t need to overthink the mounting.

Honestly, it’s fine. People act like brick is some kind of impossible material, but a masonry bit and a decent anchor and you’re done. The screen is light enough that even a couple of plugs will hold it no problem. Just don’t overthink it.

I’d just use some decent masonry anchors and take it slow with the drill, no need to overcomplicate it. The screen’s light enough that you won’t need to stress about it pulling out.

I’ve never mounted anything on brick myself but I’d probably just wing it with whatever hardware came in the box and hope for the best. It’s not like the screen weighs much so I can’t see it being a huge deal.