Does the Vanotium board ever feel too sticky after rinsing?

Mine does the same thing. I think it’s just the surface reacting to tap water, especially if you’re in an area with harder water. Once it’s completely dry it goes back to normal, so I never really worried about it. I wouldn’t call it sticky in a bad way, just a little grippy for a minute.

That tacky feeling has never really bothered me because it disappears once the board dries. I usually just leave mine propped up for a couple of minutes after cleaning and it’s fine. I would not call it a flaw, just part of the surface being what it is.

I haven’t noticed it being sticky exactly, more like it grabs a little if I wipe it and use it right away. But I always figured that’s just how the surface behaves when it’s not fully dry yet. If it bothers you, maybe just give it a minute before you start chopping and see if that changes anything for you.

It’s probably just the surface being weird with water, but I wouldn’t call it a flaw. I’ve had mine for a while and it does that too. I just don’t use it straight after washing, I let it sit for a few minutes. Not a big deal.

I actually noticed the same thing when I first got mine and it threw me off for a second. But I think it’s just how the surface reacts to plain water. Once it dries completely the tacky feeling goes away and it feels normal again. For me it only shows up if I rinse and dry it with a towel and then immediately try to use it. If I just let it sit out for a few minutes after rinsing it’s totally fine.

What I started doing is rinsing it right after I finish prepping and then leaving it in the drying rack while I plate or do whatever else. By the time I come back to put it away it’s dry and not sticky at all. It hasn’t affected anything I’ve cut on it and I honestly forget about it now. I’d say it’s just one of those quirks with the material.

That would kind of annoy me too if I was in a hurry. I usually just leave mine out on the drying rack after rinsing and by the time I get back to it, it feels totally normal. If I need it right away, I just pat it dry and deal with it for a few seconds, it doesn’t really affect anything while I’m using it.

It’s just the surface chemistry doing its thing. Mine feels slightly tacky right after a rinse too, but it’s gone within a couple of minutes. I wouldn’t call it a flaw, it’s more like the coating needs a second to fully shed the water film.

I actually kind of like that tacky feeling because it tells me the surface is still drying and I should probably leave it alone for a sec. It goes away pretty fast in my experience, like within a few minutes if you just let it sit. I think it might just be the water interacting with the coating or whatever, not really a flaw.

What I noticed is that it doesn’t really happen if I pat it dry with a paper towel and then let it finish air drying. The tackiness mostly shows up when there’s still a thin layer of moisture left that you can’t see. I’ve had mine for about two months now and it hasn’t changed or gotten worse, so I stopped thinking about it. It never affected how the board actually performs when I use it, so I just rinse, give it a quick wipe, and move on with my day.

I mean, if you’re drying it with anything, that’s probably what you’re feeling. I stopped bothering with a towel and just leave mine on the counter for a minute. Takes no time to be dry and then there’s no weird tackiness left behind.

Mine does that too if I rinse and walk away, so I just let it sit before putting it away.