Qinux Klampero for really small chains?

I think it depends on how narrow your chain really is. I used mine on a small saw and it worked okay, but it wasn’t a super tight fit. Maybe check the specs on your chain model first.

Guess it depends on the saw. Mine’s a cheap little electric too and it clamped on fine, no issues. Didn’t even check the pitch beforehand.

I wouldn’t overthink it too much. I’ve got a really basic electric saw and the Klampero clamped on without any fuss. Works fine for me.

It worked on my little electric saw without any hassle. I didn’t even check the chain size first, just clamped it on and it was fine. If it’s a standard narrow chain, you’re probably good.

I think it probably depends on the exact chain, mine is a small electric too and it clamped on okay but it felt a bit snug. Not sure if that’s normal or if yours would be the same.

I’d guess it depends on how narrow yours is. I’ve got a small saw too and it clamped on alright, but it wasn’t as snug as I expected. Still did the job for me though.

It’s probably fine. I wouldn’t overthink it, these things usually clamp on tight enough to get the job done even if it feels a little snug.

Honestly, I’d probably just try it and see. These clamp-on sharpeners mostly rely on the screw to tighten down, so as long as the chain isn’t something totally off-size, it should hold well enough to run a file through. I’d be more worried about the file size matching your chain than the clamp.

I have a small pole saw chain and it worked fine, the clamp just squeezed down enough to hold it steady. Took a few tries to get the angle right since the chain was pretty narrow but once I did it sharpened up okay.