Does the Qinux Gravizer actually work on glass?

I used mine on a couple of glass beer mugs and it worked fine for me. No skipping or scratching, just took it slow and used the diamond tip. You definitely need a steady hand but it’s not as hard as people make it sound.

I gave it a shot on a glass photo frame I didn’t care about too much, and it came out alright. I just kept the speed steady and didn’t push down hard, no scratches or anything. Feels like it’s more about getting a feel for it than the tool itself.

Honestly, I think people overthink this. It’s just an engraving pen, not a laser cutter—take it slow and it’ll be fine on glass.

Oh I’ve been wondering the same thing actually. I figure if you just go slow and don’t press down like you’re trying to carve a rock, it probably works fine on glass. Might grab one to try on a plain vase sometime.

Works fine on glass if you don’t rush it. I used mine on a plain glass plate and it didn’t skip or scratch, just took a bit of patience. Not a big deal honestly.

I’ve used mine on a few glass things and it’s been totally fine, no skipping or scratching. I think people freak out too much about it, just don’t press down like you’re trying to dig a hole.

It works if you just let the tool do the job. I’ve used mine on a few glass pieces and never had it skip or scratch anything, even on some cheap wine glasses. People overthink it.

Glass just needs a slower hand, the tip does most of the work.