ODIN SafeWave EMF on a white device, does it look weird?

I actually ended up moving mine to the inside of my case instead. Not for the looks, but because the tablet lives in a folio most of the time anyway and I figured if I was going to see a rectangle every time I flipped it open, I might as well stick it somewhere I don’t stare at. On a white back it’s just kind of there, and for me that got old faster than I expected. Everyone’s different on that front though.

The thing I’d actually pay attention to is whether you’re using a case. Mine sits under a clear-ish shell on one device and you can sort of see the outline through it, which honestly looks a little stranger than it did on the bare back. On the tablet I left it exposed and after a couple of weeks I mostly forgot it existed until I handed the thing to someone else and they asked what the sticker was. So it’s less about me noticing and more about other people noticing, if that makes sense.

If it were me, I’d leave it where it is for a bit and see if it fades into the background for you. If you’re still bugged by it after a week or two, that’s probably your answer and you can peel it and re-stick it somewhere less visible, like the inside of a case or the bottom edge. I did that with one of mine and it stuck fine the second time, no drama. Just don’t rush the decision while it still feels new.

Mine’s on a black laptop so it basically disappears, but I did put one on a light gray Switch case and yeah, you can see it. I don’t care enough to move it though, it’s just a sticker to me.

It’s a sticker. Of course you can see it on a white tablet. I put one on my white e-reader and it’s been there six months. Still visible, still fine.

A white tablet is going to show any sticker you put on it, that’s just how it goes. What I’d actually think about is whether the thing is even doing anything. I tried one of these on a router a while back and never noticed a single difference in anything. No speed change, no heat change, nothing. So the visible rectangle would bug me way more than any benefit I got from it. If it’s already stuck on there and you don’t hate looking at it, fine, but I wouldn’t buy a second one for another light colored device just to deal with the same eyesore again. At least peel it off before it sets for good if you decide it’s not worth it.

I actually kind of like the visible sticker thing on lighter devices. Sounds odd but I have a clear phone case and a white tablet, and I stuck one on the case rather than the tablet itself. On the case it almost reads like a little badge or something, so it doesn’t bug me the way I thought it would. My main preference is keeping stickers off the actual device though, mostly because I change cases a lot and I don’t want to deal with residue. So the case is my go to spot. If you’re the type who likes a totally clean look then yeah a white tablet will always show it, but I don’t think it looks weird on its own. It just looks like you put something on there on purpose. The only thing I’d watch is lining it up straight the first time, because mine was slightly crooked and that bothered me way more than the color did.

Mine’s on a light gray case and yeah, you can tell it’s there if you look. Doesn’t really bother me though. I figure anyone close enough to notice the rectangle is close enough that I’ve got bigger things to think about.

Mine actually blends in better on my white e-reader than it did on the dark one I had before, so I don’t think light devices automatically make it look worse. Maybe it depends on the finish of the surface.

I keep going back and forth on whether to grab one of these, so I’ve been reading threads like this to get a sense of what they actually look like in person. The visibility thing is part of what’s holding me up. On something like a white tablet, a small rectangle is going to show up no matter what, and I’m not sure I want a permanent mark on the back of a device I actually like the look of.

The other thing I keep wondering is what happens if you want to move it later. Adhesive stuff tends to either come off clean or leave a gummy patch, and I haven’t seen anyone mention which one this is. If it’s the second kind, that changes whether I’d put it on the device itself or just on a case.

Not trying to talk you out of it, just curious since you already committed. Did you stick it straight to the tablet or onto a case?