Qinux HydroXeltor makes a weird noise, is that normal?

Mine squeaks a little too, still going strong.

Squeaking when you change pressure is just how these things are. Mine did it from day one and it’s still spraying fine months later. If it starts losing pressure or leaking at the connection, then you’ve got a real problem.

That squeak is pretty normal for these nozzle types. It comes from the internal seal rubbing against the barrel when you twist the pressure dial, and it gets a bit louder if there’s grit or hard water buildup in there. Mine got quieter after I started detaching it from the tap when I’m done, since leaving it pressurized seems to make the seal drag more. But honestly it’s not something that means it’s about to die. If it turns into a grinding sound or the spray starts pulsing unevenly, that’s when you’d want to look at it. For now it’s just the seal doing its thing.

Mine chirped a bit early on, then quit doing it.

Squeaks are normal on these. Grinding means something’s wearing.

I picked one up mainly because it fits in the little storage bin I keep in the trunk, and at first I figured it was just another nozzle that would end up rattling around and never getting used. That changed after I actually started keeping it in the car on trips. It’s turned into the thing I grab for rinsing off beach chairs, muddy boots, the bumper after a long drive, stuff like that. So my take on it went from “probably a gimmick” to “okay this actually earns its space.”

As for the squeak, if it’s just noise when you’re turning the dial and the water still comes out the way you want, I wouldn’t go swapping parts or taking anything apart over it. That’s what I’d do, just keep using it normally and pay attention to whether the spray pattern itself starts acting up. If it ever stops holding pressure or the stream gets weak no matter where you set the dial, that’s when I’d look at it differently. But a bit of noise on its own isn’t something I’d mess with. Mine has made odd little sounds off and on, and it’s still doing its job fine.

Mine never squeaked, even after messing with the pressure dial constantly. So I don’t think that’s just how these are. If it started a few weeks in, something in the dial is probably rubbing.

Mine squeaked a bit right out of the box too, mainly when I’m between settings. It’s been sitting in my trunk for a couple months and still works the same. I just twist past that spot quick instead of easing it.

Mine started squeaking around the third week too, and it was specifically when I was turning the pressure ring. I noticed it most when I went from the wide fan setting down to the tighter stream. Not every time, but often enough that I started paying attention to it.

What I ended up doing was just slowing down when I adjust the pressure. Instead of cranking it quickly from one end to the other, I turn it a bit, let the water run, then turn it more. The squeak got quieter after that. I don’t know if that actually fixed anything or if it just worked itself out, but it hasn’t gotten worse.

Mine has been through maybe two months of regular use now, mostly for washing the fence and the back steps. Still works the same as day one aside from that noise. No leaks, no drop in pressure, nothing breaking off.

I think the squeak is just the sound of the internal parts moving against each other when you change settings. It seems to happen more when the water is on full blast. If it starts getting louder or turns into a grinding sound, that might be different. But a light squeak when adjusting pressure sounds pretty normal to me based on what I’ve experienced.